Reverse Door Swing - Whirlpool Duet YGEW9200LQ0 Use & Care Manual

You canchange y ourdoor s wing f romaright-side opening toa
left-side o pening, ifdesired.
Locate t hedoor r eversing kitthatwasshipped i nthedrum of
your d ryer. You willneed these parts tocomplete thedoor
reversal.
Loosen doortrim
1. Place atowel orsoft c lothontopofthedryer o rworkspace
toprotect thesurface.
2. Loosen t heplastic t rimabove a ndbelow thehandle f iller.
Carefully pull o utonthetrimuntil i tunsnaps. Remove the
handle f iller a ndsetaside.
3,
1. Plastic trim
2. Handle filler
Loosen the plastic trim above and below the hinge cover.
Carefully pull out on the trim until it unsnaps. Remove the
hinge cover and set aside.
Remove the door
1. Open the dryer door. Remove the 5 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening LAST
(second from the top).
2.
3.
I
Lift and pull forward on the door so that the screwhead clears
the keyhole. Remove the door.
Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the 2 screws holding the
handle to the door. Pull handle straight out and set aside. A
new handle is provided.
//
/
j//
1
1. Plastic trim
2. Hinge cover
Keep the original handle filler and hinge cover in case you
decide to return the door to its original position.
A new handle filler and hinge cover are provided in the door
reversing kit that will be installed in a later step.
4,
5,
NOTE: Keep this handle in case you decide to return the door
to its original position.
Remove the 6 screws to release the outer door assembly
from the inner door assembly (see illustration). It is important
that you remove ONLY the 6 indicated screws.
Lift the inner door assembly off of the outer door assembly.
Set the outer door assembly aside.
10