Weed Eater RTE112C Instruction Manual page 3

• Do not abuse cord, Never carry the unit by
the extension cord o r yank extension cord
todisconnect unit.
• Use c ord r etah_er toprevent disconnection
ofextension cord from unit a nd possible
damage tothe unit due t oplug m ovement
(see A 'Ci-ACH THE EXTENSION CORD
TO YOUR TRIMMER h_ the OPERATION
section).
• Do not u se t he unit ifthe switch does n ot
turn t he unit on and o ff p roperly, Repairs to
the switch must bemade byyour autho-
rized service dealer,
• Keep the extension cord c lear ofoperator
and o bstacles atall t imes. Do not expose
cords toheat, oil, w ater, or sharp edges,
• To avoid t he possibility ofelectric shock,
avoid body contact with a ny g rounded con-
ductor, such as metal fences or pipes.
• Ground Fault Circuit Interrupter (GFCI)
protection should be provided on circuit or
outlet tobeused. Receptacles are avaiF
able h aving built-in GFCI protection and
may b e used for t his measure ofsafety.
UNIT SAFETY
• Inspect unit before use. Replace damaged
parts. Make sure all handles, guards, and
fasteners are in place and securely fas-
tened. Parts that are damaged must be re-
paired or replaced by an authorized service
dealer These include head parts that are
cracked, or chipped, guards, and any other
part that is damaged.
• Do not repair unit yourself.
• Use only 0.065 inch (1.65 mm) diameter
recommended trimmer line (see USER RE-
PLACEABLE SERVICE PARTS in the
SERVICE AND ADJUSTMENTS section).
Never use wire, rope, string, etc.
• Use specified trimmer spool. Make sure
spoot is properly installed and all parts are
securely fastened.
• Use only WEED EATER replacement parts
and accessories as recommended.
CUTTING SAFETY
_,WARNING:
Inspect area to be cut.
Remove objects (rocks, broken glass, nails,
wire, string, etc.) which can be thrown or be-
come entangled in cutting head,
• Donotoverreachorstandon unstablesup-
port, Keep firm footing and balance.
• Keep the cutting head below waist teveL Do
not raise handles above your waist, Cutting
head can come dangerously close to your
body,
• Keep away from cutting head and spinning
line.
• Use unit properly. Use only for trimming,
edging, scalping, and mowing, Do not force
unit, It will do the job better and with less risk
of injury at the rate for which it was de-
signed.
• Use only in daylight or in good artificial light.
MAINTENANCE SAFETY
,_ WARNING:
Disconnect unit from the
power supply before performing mainte-
nance, or when changing trimmer line,
• Maintain unit according to recommended
procedures. Keep cutting line at proper
length, Follow instructions for changing
trimmer Iine,
• Have all service and maintenance not ex-
plained in this manual performed by an au-
thorized service dealer to avoid creating a
hazard.
• Never douse or squirt the unit with water or
any other liquid. Clean unit and labels with
a damp sponge. Keep handles dry, clean,
and free from oil and grease.
• Keep the air vents clean and free of debris
to avoid overheating the motor. Clean after
each use.
TRANSPORTING AND STORAGE
• Stop the unit and disconnect the power
source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter blade (on
underside of shield) cannot cause injury.
• Store unit indoors in a high, dry place out of
the reach of children. Store unit unplugged.
• Do not hang unit so that the trigger switch is
depressed.
DOUBLE INSULATION
CONSTRUCTION
This unit is double insulated to help protect
against electric shock. Double insulation
construction consists of two separate "layers"
of electrical insulation instead of grounding.
Tools built with this insulation system are not
intended to be grounded. No grounding
means is provided on this unit, nor should a
means of grounding be added to this unit. As a
result, the extension cord used with your unit
can be plugged into any standard 120 volt
electrical outIet.
Safety precautions must be observed when
operating any electrical tool. The double in-
sulation system only provides added protec-
tion against injury resulting from an internai
electrical insulation failure.
_I'WARNING; All electrical repairs to
this unit, including housing, switch, motor,
locking sleeve assembly, wires, etc., must be
diagnosed and repaired by qualified service
personnel. Replacement parts for a double in-
sulated appliance must be recommended by
the manufacturer. A double insulated ap-
pliance is marked with the words "double in-
sulation" or "double insulated". The symbol
(square within a square) [] may also be
marked on the appliance. Failure to have the
unit repaired by qualified service personnel
can cause the double insulation construction
to become ineffective and result in serious
injury.
SAVE THESE INSTRUCTIONS