Table of Contents
Advertisement
Troubleshooting
Most problems you encounter
with your TV can be corrected by consulting
the
following
troubleshooting
list.
Note for U,S,customers Ir you prefer, we can provide you with the nameof an AuthoriTed Servk'e
Representativewho will visit your home for a feeto install your electronic entertainment system
and to instruct you in its operation. Fordetails about this service call 1-888-206-3359, For
additional assistancewhile using your RCApmduct; pleasevisit wwwrca,com/eustomersupport
r_/Problems
TV won't
turn
on
*
PresstheIV
button.
*
Make sure the ]_/is plugged in.
Check the wall receptacle (or extension cord) to make sure it is "live" by plugging in
something else.
*
Something might be wrong with your remote control Press the POWERbutton on the
front of the TV. If the TVturns on, cheek the remote control solutions on page 23.
The front panel controls may be locked (disabled). Use the remote control to unlock the
front panel controls by selecting the Lock Fn Panel in the PARENTAL(?ONTROL menu and
press OK (box won't have check mark).
Buttons
don't
work
If you're using the remote control, press the T_!button first to make sure the remote is in
?v' mode.
The front panel controls may be locked (disabled). Use the remote control to unlock the
front panel controls by selecting the Lock Fn Panel in the PARENTALCONTROLmenu and
press OK (box won't have check mark).
Unplug the TV for two minutes and then plug it back in. Turn the IV on and try again.
TV turns
off
unexpectedly
Sleep timer might have been aetiw_ted. Go to page 21 for instructions.
Wake-Up timer turned on the IV and no remote or front panel buttons were pressed for
two hours.
Electronic protection circuit may have been activated because of a power surge. Wait
30 seconds and then turn on again. If this happens frequenth/, the voltage in your
house may be abnormally high or low.
Unplug IV. Wait five minutes. Plug it in again.
TV turns
on unexpectedly
*
Wake-Up timer might have been activated. Go to page 21 for instructions.
*
You might have pressed ¢H+, CH- or OK on the remote accidentally.
Blank
screen
*
Make sure the cornponent connected to the -IV is turned on,
*
Try another channel
22
Graphics contained
within this publication
_lre f_)r representation
onl_
Chapter 5
Advertisement
Table of Contents
