Table of Contents
Advertisement
Troubleshooting
Tips
No power
•
Check to make sure it is plugged into an operating outlet.
•
Check to make sure your connections are correct.
VCR does not respond to remote
•
Press VCR to set remote to control the VCR.
•
Check to make sure there are no objects between the VCR and remote.
•
The batteries may need changing.
•
Make sure the Remote VCRINCR2
setting is set to VCR1 so the remote that came packed with your VCR
can operate it.
•
Remove batteries and hold number button 1 for at least 60 seconds to drain the microprocessor
inside
the remote. Release number I and replace the batteries.
•
Remove all batteries for approximately
12 hours. Then replace batteries.
Remote no longer controls a GE, RCA, or ProScan TV
•
Press "IV to set remote to control a compatible TV.
•
Check to make sure the remote is programmed
to control a GE, RCA, or ProScan TV.
Remote
no longer controls
a compatible
TV
•
Press TV to set remote to control the compatible TV.
•
Check to make sure there are no objects between the TV and remote.
•
The batteries may need changing.
•
Reprogram remote after batteries have been changed.
•
Remove batteries and hold number button 1 for at least 60 seconds to drain the microprocessor
inside
the remote. Release number 1, replace the batteries, and (if necessary) reprogram the remote.
•
Remove all batteries for approximately
12 hours. Then replace batteries and (if necessary) reprogram the
remote.
Poor or no picture
for normal TV viewing
•
Check to make sure the VCR indicator is off.
•
Check to make sure the "IV is switched to an active channel.
•
Check to make sure the antenna connections are secure and correct.
Snowy
or no
picture during playback
•
Press TV-VCR to turn VCR indicator on.
•
Check TV channel selected (3 or 4) to make sure it matches the channel selected with 3 CH 4 switch on
back of VCR.
•
Check to make sure the TV's fine tuning is correct for the channel you have selected.
•
Check video cable connections between VCR and "IV monitor.
•
Check to make sure the "IV monitor is set to video input channel.
51
Advertisement
Table of Contents
