RS2518/19-EN
3/29/01
9:43
AM
Page
12
1. PressSOURCEto select TUNER.
2. PressBAND to select between AM or FM radio
band.
Tip: Your audio s ystem has32preset staticss.
Setting Presets
1. PressSKIP FORWARD/BACKWARD to accessthe
desired frequency.
2. Pressthe SET button once.
3. The most recentlyaccessedprogram location will
be displayed.
4. If a different program location ispreferred, press
SKIP BACKWARD I FORWARD to move to the
desired preset number (1-32).
5. PressSET to store the selected frequency at that
preset.
Tuning to a Station
Press SKIP FORWARD/BACKWARD to select fre-
quencies.
Suppressing Stereo Signal
PressFM ST to toggle between FM mono and stereo
for stereo FM stations, (Remote Only)
Using Presets
The tuner can be either
TUNE or PRESET mode.
When in PRESET mode, the PROGlight is on.
Press SKIP BACKWARD or SKIP FORWARD on the
main system or PRESETUP or DOWN on the remote
control to accessthe previous or next preset station.
The display first shows the preset program number
and after a few seconds, the frequency and preset
program number will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset
Programming
(for FM only)
Pressand hold BAND
button for 2 seconds to scan stations in FM band. The
stations wilt then be stored as preset channels. A maxi-
mum 32 stations can be stored. Beware of your preset
channels being erased accidentally because the scan-
ning and storing process is automatic upon pressing
the button. You can stop the automatic scan by press-
ing any button, but the erased stations cannot be
recovered.
"°.... ..............................................................................................................................................................................
.°.°"
_8