Table of Contents
Advertisement
Trouble Checks
Trouble
i
i
yC__RR (,o.Unued
Can't record one channel
with the VCR while
watching
a different
channel
on the TV
Checks
and Adjustments
i
llJl
For connections
4B, 5B:
1. Turn on TV, VCR, satellite receiver, and cable box (if required).
2. Make sure IRD/TV switch on satellite receiver is in TV position so signal
from cable box or antenna
is coming out the OUT TO TV jack on the
satellite receiver.
3. If cable box is required, use CHANNEL buttons on VCR to tune VCR to
output channel of cable box (usually 02, 03, or 04).
4. Select channel 03 or 04 on TV (depending
on the position of the
CH3/CH4
switch on the back of the VCR).
5. Select desired channel with CHANNEL buttons on cable box if cable box
is required.
If cable box is not required,
select desired channel with
CHANNEL buttons on VCR.
6. Insert tape in VCR and press RECORD
on VCR.
7. To watch satellite channel, select channel 00 on TV.
8. Then select desired channel to watch with CHANNEL buttons on
satellite receiver.
For connections
4C, 5C:
1. Turn on TV and select channel 00 on ]_ with remote.
2. Turn on satellite receiver and select desired satellite channel with
CHANNEL buttons on satellite receiver.
3. Turn on VCR and set it to line mode (see glossary) so you can see the
satellite signal coming into its AUDIO/VIDEO IN jacks.
4. Insert tape in VCR and press RECORD on VCR.
5. Press TV/VCFI button on VCR. This lets the cable signal flow directly
out of the OUT TO TV jack of the VCR without affecting the recording.
6. If cable box is required,
turn on cable box, change channel
on TV to
output channel of cable box (usually 02, 03, or 04), and select desired
channel
with CHANNEL buttons on cable box.
7. If cable box is not required,
select desired channel with CHANNEL
buttons on TV.
continued on the next page
25
Advertisement
Table of Contents
