Table of Contents
Advertisement
THE PIP (PICTURE-IN-PICTURE)
FEATURE
The PIP (picture-in-picture)
feature
lets you display a second, smaller
picture on top of the main picture,
If the PIP window
is displayed,
and
you change the PIP input (by pressing WHO.INPUT)
to COMP2, PIP is
not displayed.
If you press the PIP button
while viewing
COMP2, the
PIP window
is not available.
(N/A) appears in the channel marker.
Important:
Your TV has a single tuner that tunes to cable or off-air
television
channels, In order for the second picture (the PiP picture) to
appear on the screen, you must connect another
component
(like a
satellite
receiver or VCR) to the TV, You need to use audio/video
cables
to connect the component
to the TV. Go to the Setup and Connections
section, for more information.
How To Use PIP
Tip
While you can use PIP in different
ways, this basic PIP scenario should get you started, While
watching
the TV, follow
these steps to use your VCR to supply the picture for PIE
Main
A quick way to tune the PIP window
to
the correct video input channel, is to set
up auto tuning
in the menu system. Go
to page 16 for instructions.
1.
The TV must be on, Tune to the channel you want to watch, Press
the PIP button
on the remote (the PIP picture appears with the
same picture in it as the main picture).
2.
Turn on theVCR,
3.
If the picture gets fuzzy, press the TV/VCR button
on the VCR.
4.
To see a different
picture in the PIP window.
. Press the TV button
on the remote control
Picture
5_
AnowandOK
4_D
buttons
O_C
00,C
O,OC
=_;.o o ,_
PIPbuttons --
_
The main PIPbuttons (PtR CH CTRLand SWAP)
are at tile bottom of tile remote control
5.
6,
• Press the WHO.INPUT
button
on the remote until you see the
picture that's coming from the VCR (PIP WD1 or PIP WD2
appears on the screen, depending
on which input jack you use.)
To change the picture in the PIP window,
you need to change the
channel on the VCR because the VCR is the second signal source,
Press the channel buttons
on the VCR or on the VCR's remote
control,
To change the channel in the main picture, press CH CTRL until
the main channel number appears highlighted
(yellow),
Press the
channel up or down buttons
on the remote control.
Note: The channel up and down buttons won't
work correctly
when
the VIE) channel is highlighted
(yellow).
How
to
Use Swap
Atypical way to use the SWAP button is to scan through the channels
in the PIPwindow, and when you find a channel you want to watch,
press SWAP on the remote to send that channel to the main picture.
51
Advertisement
Table of Contents
Troubleshooting
