Konica Minolta Konica DIMAGE X1 Instruction Manual page 5

A_CAUTION
• Do not use or store these products in a hot or humid environment such as the glove compartment
or trunk of a car. It may damage the camera, cradle, and battery which may result in burns or
injuries caused by heat, fire, explosion, or leaking battery fluid.
• If the battery is leaking, discontinue use of the product.
• The camera, cradle, and battery temperature rises with extended periods of use. Care should be
taken to avoid burns.
• Burns may result if the memory card or battery is removed immediately after extended periods of
use. Turn the camera off and wait for it to cool.
• Do not fire the flash while it is in contact with people or objects. The flash unit discharges a large
amount of energy which may cause burns.
• Do not apply pressure to the LCD monitor. A damaged monitor may cause injury, and the liquid
from the monitor may cause inflammation. If liquid from the monitor makes contact with skin,
wash the area with fresh water. If liquid from the monitor comes in contact with the eyes, immedi-
ately rinse the eyes with plenty of water and contact a doctor.
• When using the AC adapter and cradle, insert the plug securely into the electrical outlet.
• Do not use electronic transformers or travel adapters with the cradle. The use of these devices
may cause a fire or damage the product.
• Do not use if the AC adapter or cradle cord is damaged.
• Do not cover the AC adapter or cradle. A fire may result.
• Do not obstruct access to the AC adapter or cradle; this can hinder the unplugging of the units in
emergencies.
• Unplug the AC adapter or cradle when cleaning or not in use.
The following marks may be found on the product:
f This mark on your camera certifies that this camera meets the requirements of the
EU (European Union) concerning interference causing equipment regulations. CE
stands for Conformite Europeenne (European Conformity).
This Class B digital apparatus complies with Canadian ICES-003.
FCC Compliance Statement
Declaration on Conformity
Responsible Party: Konica Minolta Photo Imaging USA Inc.
Address: 725 Darlington Avenue, Mahwah, NJ 07430
I Digit d_amet c D MAGE Xl
Tes ed T 3 C 3rap y
With FCC SI mduds
FOR HOME OR OFFICE USE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or modi-
fications not approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Do not remove the ferrite cores from the cables.