Specifications - Panasonic CT-9R20 Manual

Your new television leatures a solid state chassis
which is designed to give you many years ot
enjoyment. It was thoroughly tested and tuned at
the factory Ior best performance,
Customer Record
The model and serial number of this product are
located on the back of the unit, You should note
the model and serial number in the space provided
and retain as a permanent record of your
purchase, This will aid in identification in the event
of theft or loss.
Product registration is available to U.S, customers
at:
www.prodreg.conVpanasonlc
Model
Number
Serial
Number
Care and Cleaning
Screen (Turn TV Off)
• Use a mild soap solution or window cleaner
with a soft clean cloth. DO NOT USE
ABRASIVE CLEANERS.
• Avoid excessive moisture and wipe dry.
Cabinet and Remote Control
• Use a soft cloth dampened with water or a
mild detergent solution, Do not use benzene,
thinner or other petroleum based cleaners.
° Wipe dry with a soft clean cloth, Avoid
excessive moisture.
Specifications
Power Source
CT-9R11
CT-9R20
Channel Capability - 181
120V AC, 60Hz
120V AC, 60Hz and
12V DC
VHF-12; UHF-56;
Cable-125
Specifications are subject to change without notice
or obligation.
Television Location
• Avoid excessive sunlight or bright lights,
including reitections.
• Keep away from excessive heat or moisture,
Inadequate ventilation may cause internal
component failure,
• Fluorescent lighting may reduce remote
control transmitting range,
• Avoid magnetic equipment, including motors,
fans and external speakers.
I Optional Cable Connections
Shielded audio and video cabies should be used
between components. For best results:
• Use 75 Ohm coaxial shielded cables.
• Use appropriate input and output
connectors that match your component
connectors.
• Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT
ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET Polarized plug
AND FULLY INSERT, DO _,JF_
NOT USE A PLUG WITH A
RECEPTACLE OR OTHER Nen-Poladzedplug
OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
FOR SOME MODELS THAT ARE NON-
POLARIZED, THE USE OF AN AC ADAPTOR
CONNECTOR MAY BE NECESSARY.
Batteries
• Replace batteries in pairs.
• Do not mix battery types (zinc carbon with
alkaline).
• Do not recharge, short-circuit, disassemble.
heat or burn used batteries.
Cable / Antenna
For proper reception, either a cable or antenna
connection is required.
Cable Connection
• For reception of
cable channels,
connect the
cable supplied
by your local
cable company.
° Antenna Mode
must be set to
CABLE,
Incoming Cable from
Cable Company
75 Ohm
VHF/UHF on back o_"IV
Note: A cable converter box may be required
for proper reception, Check with your
local cable company for compatibility
requirements,
Antenna Connection
• For proper Incoming Cable from
reception of VHF/ Home Antenna
UHF channels, an
external antenna is n_"_ _
required. For best
reception, an
outdoor antenna is
recom mended.
• Antenna Mode
must be set to
television.
-2-