Using Timer; Operating Peripheral Equipment - Panasonic TH-42PX77U Operating Instructions Manual

38
Using Timer
The TV can automatically turn On/Off at the designated date and time.
@The Clock must be set before On time/Off time settings. (p. 18)
@The "Sleep" timer and "On / Off timer" will not function if "Auto power on" (p. 29)is set.
Display menu
Select "Timer"
• Press to exit from
menu screen
EXIT
• Press to return
to the previous
screen
RETURN
@
Note
@The TV automatically
turns Off after 90
minutes when turned
On by the Timer.
This operation will be
cancelled if the Off
time is selected or if a
key is pressed.
OTimer
Select the timer to set
Set the timer
select
next
I
I
Sleep I Turns Off automatically
Timer 1 I Turns On/Offautomatically
I (5 timers can be set.)
Timer 5 I
mTo set "Sleep" (Off Timer)
Set to shut the unit off after a pre-selected amount of time.
@0/30/60/90 (minutes)
mTo set "Timer 1-5" (On/Off Timer)
Select the item and set
I Channel I Select the channel
I Day I Select the day
IiV N/MON/TU E/WED/TH U/FRt/SAT
isplays the nearest future date)
ON-FRI/SAT-SUN/DAILY/EVR SUN/EVR MON/
R TUE/EVR WED/EVR THU/EVR FRI/EVR SAT
I On time
I The
time to turn On
I Off time I The time to turn Off
I Set I Timer setting (On/Off)
Operating Peripheral Equipment
You can operate other manufacturers' equipment using this TV's remote control.
Connect the external equipment to the TV and
Power Off the external equipment
POWER
+
VCR DBS/CBL
DVD
Press both buttons simultaneously for
more than 3 seconds.
@Release the buttons when the equipment selection
buttons start flashing.
Select the equipment
with the equipment selection button
@The selected button remains lit (other buttons are not lit).
D_m
DBB
_DQ
m
Input the equipment's 4-digit remote
control code (p.43-45)
• Press to return to the TV
mode
"iV
POWER
Operate the equipment with the remote
control
(p. 42)
@The external equipment turns On.
• If the equipment does not operate with the
remote control
@When your equipment has a single code
®, Input the remote control code again
@When your equipment has multiple codes
÷ Change the code with _ above and test again
@Registration will fail if the wrong code is input or it takes more than 30 seconds to register.
This procedure searches all codes and is called the "sequence method."
_After step @ above, change the code and @_When the correct code is found
test
POWER
- change
;_ Operate the equipment with the remote
control (p. 42)
@ Repeat until the code is found
@It may take many attempts before the correct
code is found
O
(D
(£3
33
CD
.-£
:3-
®5
93
__1-_
39