Programming The Remote Control - LG 47LB1DA Owner's Manual

PROGRAMMING THE REMOTE CONTROL
The provided universal remote control can be programmed to operate most remote-controllable devices.
Note that the remote may not control all models of other brands.
Programming a code into a remote mode
@
To find out whether your remote control can operate each device without programming, turn on the device
(such as a VCR) and press the corresponding mode button on the remote.
After that, press the POWER button, if the device is turned off and it responds properly the remote control
need not be programmed. If noL the remote should be programmed to operate the device. The program-
ming procedures are explained below:
0
Press the MENU and MUTE button continuously at the same time for two seconds the currently selected
device button is illuminated.
if you don't press any button for 20 seconds, the light on the mode button will be turned off. in that case,
you have to repeat from step 2.
O Enter the appropriate code from the code table on the following pages. When pressing the button, the light
blinks at a time. If the device turned off, the programming is successful.
O ress the MENU button to store the code. After blinking twice, this code is stored.
O Test the remote control functions to see if the device responds properly. If not, steps 2°5.
I
rll
z
x
117