Table of Contents
Advertisement
Reference
Programming
the Remote
I_
The remote control
is a multi-brand
or universal
remote control
It can be programmed
to operate most
remote_controHable
devices of other manufacturers.
Note that the remote control
may not control nil models of other brands.
:v
vc_C_LE gyp_s:_
0
o
o
o
o
_O,E
_._FO POWE£
00o
iNPUT
MIJL_EDIA
EZ PIC
AEkJU_
S,IG NA_
_ SOUND
O0
®@@
®@@
®@@
@
PIP
P:_H-
PIPOI_
_AP
0000
PLAY
PAUSE
SltOP
R#_,_,g_D
®®®®
REW
FF
i,
2,
3.
4,
5,
6_
Test your remote control.
To find out whether
your remote controt can operate the component
without
programming,
turn on the component
such as a VCR and press the corre-
sponding
MODE button (VCR)
on the remote control,
whiie illuminating
on
the setected
component.
Test the POWER
button to i see if the component
responds
properly,
if not, the remote requires
programming
to operate the
device,
Turn on the component
to be programmed,
then press the corresponding
MODE button on the remote control.
Press the MENU and MUTE buttons simultaneously
for 2 seconds,
the but-
ton selected
component
lights on the remote controt.
If you don't press any
button
for 20 seconds,
the button
selected
component
wilt turn off on the
remote control. At a moment,
you have to repeat from step 2,
Enter a code number using the number buttons on the remote. When press _
ing the button, the tight is blinked at a time. Programming
code numbers
for
the corresponding
component
can be found on the following
pages. Again,
if the code is correct,
the device will turn off.
Press the MENU button: to store the code. After blinking twice, this code is
stored,
Test the remote control functions
to see if the component
responds
proper-
iy. If not, repeat from step 2.
53
Advertisement
Table of Contents
