Cutting Height; Gasand Oil Fill-Up - MTD 11A-A44E000 Operator's Manual

Adjustments
CuttingHeight
Each wheel can be adjusted to change the cutting height of the
mower.
1.
2.
Remove the shoulder bolts and washers from the wheels as
shown in Fig. 3-8.
Reattach the wheels with shoulder bolts and washers in
one of the four available holes on the deck. Remember to
attach ALL wheels at the same relative position to ensure
an even cut. Refer to instructions for attaching the wheels
in the previous step. For a higher cutting height, use the
lower hole; for a lower cutting height, use the upper hole.
IMPORTANT:When adjusting the cutting height, be sure to
set all four wheels at the same height. For rough or uneven
lawns, move the wheel to a higher position to prevent
scalping of the grass.
Set-Up
Gasand Oil Fill-Up
Refer to the separate engine owner's manual for additional
engine information.
I. Add oil provided before starting unit for the first time out
of the box.
2. Service the engine with gasoline as instructed in the
separate engine owner's manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
F
Figure 3-8
12 I SECTION 3 -- ASSEMBLY & SET-UP