Spark Arrestor; Maintenance And Storage - MTD 550 Series Operator's Manual

Hide thumbs Also See for 550 Series:
Table of Contents

Advertisement

Available languages

Available languages

13.
Keep your work area clean. Immediately
remove
split wood
around the machine
so you do not stumble
over it.
14.
Do not change the engine
governor
settings
or overspeed
the engine. The governor
controls
the maximum
safe
operating
speed of the engine.
15.
Never move this machine
while the engine
is running.
16.
This machine
should
not be towed on any street, highway
or public
road without
checking
the existing
federal,
state, or local vehicle requirements.
Any licensing
or
modifications
such as taillights,
etc., needed
to comply,
is
the sole responsibility
of the purchaser.
Ira "Statement
of
Origin"
is required
in your state, see your local dealer.
17.
Do not tow machine
over 45 mph.
18.
See Transporting
the Log Splitter section
in this manual for
proper
towing
instructions
once all federal,
local, or state
requirements
are met.
Maintenanceand Storage
1.
Stop the engine,
disconnect
the spark plug and ground
it against the engine
before cleaning,
or inspecting
the
machine.
2.
Stop the engine
and relieve hydraulic
system pressure
before repairing
or adjusting
fittings,
hoses, tubing,
or
other system components.
3.
To prevent
fires, clean debris and chaff from the engine
and muffler
areas. If the engine
is equipped
with a spark
attester
muffler,
clean and inspect it regularly
according
to
manufacturers
instructions.
Replace if damaged.
4.
Periodically
check that all nuts and bolts, hose clamps, and
hydraulic
fittings
are tight to be sure equipment
is in safe
working
condition.
5.
Check all safety guards and shields to be sure they are in
the proper
position.
Never operate
with safety guards,
shields, or other protective
features
removed.
6.
The pressure relief valve is preset at the factory. Do not
adjust the valve.
7.
Never attempt
to move this machine
over hilly or uneven
terrain without
a tow vehicle or adequate
help.
8.
For your safety, replace all damaged
or worn parts
immediately
with original
equipment
manufacturer's
(O.E.M.) parts only. "Use of parts which do not meet the
original
equipment
specifications
may lead to improper
performance
and compromise
safety!"
9.
Do not alter this machine
in any manner, alterations
such
as attaching
a rope or extension
to the control
handle, or
adding to the width
or height of the wedge
may result in
personal
injury.
10.
According
to the Consumer
Products
Safety Commission
(CPSC) and the U.S. Environmental
Protection
Agency
(EPA),
this product
has an Average UsefulLife
of seven (7) years,
or 130 hours of operation.
At the end of the Average Useful
Life have the machine
inspected
annually
by an authorized
service dealer to ensure that all mechanical
and safety
systems are working
properly
and not worn excessively.
Failure to do so can result in accidents,
injuries
or death.
Spark Arrestor
_k
ARNING:
This machine
is equipped
with an
internal
combustion
engine and should
not be used
on or near any unimproved
forest-covered,
brush
covered or grass-covered
land unless the engine's
exhaust
system is equipped
with a spark arrester
meeting
applicable
local or state laws (if any).
If a spark arrester is used, it should
be maintained
in
effective
working
order by the operator.
In the State of California
the above is required
by law (Section 4442 of the California
Public Resources Code). Other states may have similar laws.
Federal laws apply on federal
lands.
A spark arrester for the muffler
is available
through
your
nearest engine authorized
service dealer or contact
the service
department,
RO. Box 361131 Cleveland,
Ohio 44136-0019.
SECTION 2 --
IMPORTANT SAFE OPERATION
PRACTICES
S

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents