Maytag MTB1504ARW Use & Care Manual page 7

Loohing Inside
Fresh Food Compartment
Shelves
To Reinstall:
• While holding the shelf on each end, slide the shelf
in and down.
• Push down on the interior center of the shelf to snap
it completely into place.
Select models are equipped with full width shelves that
are supported by rails molded into the interior walls of
the fresh food compartment. These shelves can easily
be adjusted to alternate positions within the
compartment.
To Adjust a Shelf:
• Grasp each side of the shelf.
• Pull the shelf forward approximately 1".
• While supporting the shelf from underneath, lift it up
and out.
• Slide the shelf into the desired alternate position.
The bucket-style Door Shelves accommodate a variety
of container sizes and shapes.
To Remove:
• Grasp the shelf on each end.
• Lift the shelf up and out.
The Crispers provide a storage area for fruit and
vegetables. Some crisper drawers have slide humidity
controls.
For fruit storage, slide the control (select models) to
the left to provide lower humidity conditions in the
d rawer.
For vegetable storage, slide the control (select models)
to the right to provide higher humidity conditions in the
drawer.
For best results, keep the crispers tightly closed.
To Remove:
• Pull out the crisper until it stops.
• Tilt the drawer up slightly and pull it out.
To Reinstall:
• With the drawer tilted up slightly, align the drawer in
the tracks and slide in.
The Crisper Top serves as the lower refrigerator shelf.
To Remove:
• Remove the crisper drawers.
• Slightly lift up the front of the shelf.
• Support the shelf from underneath to lift it up and
then out of the cabinet.
To Reinstall:
• With the shelf front tilted slightly upward, carefully
insert the crisper top back into the cabinet.
• Position the rear and sides of the shelf on the
supports and let the crisper top settle into place.