Advertisement
IMPORTANT
SAFETY
INSTRUCTIONS
Read before operating
equipment
1.
Read these insmtctiuns.
2.
Kanp these instructions.
3.
Hc_xl all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near watur.
6.
Clean only with a dry cleft1.
7.
Do not block any of"the vantilation openings. Install in accordance
with the ManUfanturc*s instructions.
8.
Do not ingall near any heat souraas sunh as radiators, heat regis-
tc_, stoves, or other apparatus (including amplificra) that produc_
heat.
9.
IX_ not defeat the safety purpose, of the polarized or grounding-
type plug. A pal arir_d plug has two blades with one wider than
the othur. A grounding type plug has two blades and third ground-
ing prong. The wide blade or third prong am grovided for your
s_fety. When the providexl plug deas not fit into your outlet, tun-
suit an electrician for replaceMant of the obsolete outlet.
10, Protnct the power cord fraM being walkcxl on or pinchad particu-
larly at plugs, cunveniance rc_:_p_clas, and the point whom the)"
exit froM tim apparatus.
11. On.so
arcachMantsiaccassuries
specificxl by file manufacturer.
12, _
Use only with a cart, stand, tripod, bracket, or table
_
specified by the ManUfanturar, or sold with file app-
,_._
aratus. When a.cart ...... is uscxl, use caution when MOVing
the cartgapparatus combmatlon to avoid mjury froM tip-over.
13, Unplug*his apparatus during lightning storms or when unu_xl for
long pariods of"time,
14, Refer all servicingtoqualificxlscevicepe_unnel.
Sca_,icingis
rcquirad when the apparatus has been damagcxl in any way, such
as pewar-supply
cord or plug is damagcxl, liquid has been Sl_illcxl
or objects have fallen into apparatus, the apparatus has been
expe_xl to rain or Moisture, does not operate normally, or has
been dropped.
15, q-his groduct May contain lead and mercury. Disposal of"these
matarials May be ret,ntlatcxl due to anvironmental c*_nsideratiuns.
For disposal or racycling informatiun, please contant your local
authuritias or the Elec_unic Industrias Alliance: www.eian.org
lg,
IIlmmge Requlri_g
Servlee - The applianc_ should be serviocxl
by qualificxl _r_fic_ parsotmc] when:
A,
"[he pewar supply cord or the pfag has be_
damagcxl; or
B.
Objects have fallen, or liquid has beta spilled into tim appli-
atlce;
or
C,
The appliance has be_n expo_xl to rain; or
II,
The appliance deas not appear to operate normally or
c_libits
a marked change in pcrforrnanc_; or
I_.
The appliance has be,an dropped, or tim cnclosura damagcxl.
1% "Hit"Stability - All telcMsions must comply wifll rc_:xmunended
international
global s_fety standards for the and stability propartias
of its cabinet design.
• Do not C*_MgrOMiSe t hese design standards by applying exces-
sive pull forc_ to the front, or top, of"the cabinet which could ulti-
mately overturn the groduct.
• Also, do not endanger yourselL or childran, by placing olc_:,t'ran-
ic cquipMantiloys on the top of the cabinet. Such itnMs could
unsuspectingly
fall from the top of the set and cause groduct dam-
age and/or personal injury.
18, Wall or Ce'lling Motmling - The appliance shouid be mounted to
a wall or ceiling only as rc_:xmunended by the Manufacturcx.
19, Power Linas - An outdour antutma should be locatcxl away from
power lines.
20,
Outtloor Amenna Groundlng - If an outside antenna is connect-
CAtO the reCC/lVar, b e sure the antetma system is grounded so as to
grovide some Irrotuction againg voltage surges and built up static
charges.
Sc*:,tiun810 of the National Electric Code, ANSIiNFPA No. 70-
1984, grovides infunmatiun with respe_:,tto proper grounding of
the Mast and supporting stractam, grounding of the lead-in wira to
an antutma discharge lmit, sirz of grounding connc*:,tors, location
of antenna-discharge
unit, cx_nnection to grounding elec_odes, and
raquirements for the grounding elec_ode. San Figttra below.
21,
Ollject arid Liquid Enlry - Care shouid be taken so that objects
do not fall and liquids ara not S!glllcxlinto the enclosure through
openings.
22, BatEery Usage CAU FtON - To prcxent battery leakage that may
result in bodily injury, property damage, or damage to the unit:
• lilgall all batt_as
correctly, with -_ and - aligned as Marked on
the lmit.
• Do not mix battcNas (old and new or carbon and alkaline, etc.).
• ReMove battarias when the unit is not or_d for a long time.
Note to the CATV system insr.aJle_ This reminder is provided to call the CATV s)_tem installer'sattention to Article 820-40 o_ the NEC
that provides guidelines _or proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system oi the
bui ding, as c ose to the point o_ cabe entry as pracCica.
Example
of Antenna
Grounding
as per NEC
- National
Electric
Code
GRUUDD ULANP
ANTEDNALEAD IN WIRE
3
Advertisement
