Copying A Video Cassette 14 (Requires A Vcr Or Camcorder) - Sears LXI 934.44709990 Owner's Manual

This function enables you to set a recording
length simply by pressing the REC/OTR button
on the TVNCR.
Make sure:
• TVNCR power must be turned on.
• Insert a cassette tape with its erase preven-
tion tab in place. (If necessary, rewind or fast
forward the tape to the point you want to be-
gin recording.)
NOTE"
• This function CANNOT be done from the re-
mote control.
• Recording starts immediately when the
REC/OTR button is pressed.
• When the REC/OTR button is pressed 18
times, the TVNCR returns to the Normal
Recording mode.
• To stop the OTR operation, press the STOP
button on the TVNCR or on the remote con-
trol.
• To show the remaining time, press the DIS-
PLAY button on the remote control so that
"OTR" appears on the TV screen. (It will show
up momentarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode, maximum
recording time, is 8 hours using a T-160 or 6
hours using T-120 tape.
• If the tape runs out before the end time, the
TVNCR will switch to the Stop mode immedi-
ately, ejects the tape and turns itself off.
1
Select the channel to be recorded
Press the number buttons on the remote control
or the CHANNEL • or • button.
Remember: If the rVNCR is connected to a ca-
ble box or satellite box, the TV/VCR must be on
CH3 or CH4, then the channel to be recorded is
selected on the cable box or satellite box,
2
Select the tape speed
Press the SPEED button to select the desired
tape speed (SP/SLP).
3
Begin OTR
Press the REC/OTR button
once to begin recording,
Ii rR(2:30)
Press twice to set recording length to 30 minutes.
Each additional push of the button will increase
the recording time by 30 minutes, up to a total of
480 minutes.
Push(es)
1 push
2 pushes
3 pushes
17 pushes
Display Recording length
(Be in Recording)
0:30 30 minutes
1:00 60 minutes
J, J,
8:00 480 minutes
Unauthorized recordings
of copyrighted video tapes may be an
infringement of copyright laws,
Connect your TVNCR and a Source (Playing)VCR
using the following diagram.
[The TVNCR]
[Ex: Source(Playing)VCR
or camcordar]
adapter cable k @"=@
(notsupplied) _,_
1) Insert a pre-recorded video cassette into the
Source (Playing) VCR or camcorder.
2) Insert a blank video cassette, or one you want
to record over, into the TVNCR's cassette
compartment.
3) Press the SPEED buttonon remote controlfor
the TVNCR to select the desired recording
speed (SP/SLP).
4) Press the CHANNEL • or • button on the
TVNCR until "AUX" appears on the screen.
5) Press the RECORD button on the TVNCR.
6) Begin playback of the tape in the source (Play-
ing) VCR or camcorder.
NOTE: For best results during copying, use the
rVNCR's front panel controls whenever possi-
ble. The remote control might affect the source
(Playing) VCR's playback operation.
- 24 - EN
6K03