KitchenAid KUDA03CTBL2 User Instructions page 4

Depending onyour w ater h ardness, filltheMain Wash s ection
ofthedispenser asshown. Fill t hePre-Wash section tothe
level s hown, ifneeded.
NOTE: Fillamounts shown
areforstandard powdered
detergent. Follow
instructions onthepackage
when using other
dishwasher detergent.
MainWash Pre-Wash
Add Rinse Aid
• Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
• Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
• Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.
• Check the rinse aid indicator. Add rinse aid when indicator
drops to "Add" level.
To add rinse aid, turn the dispenser cap
to "Refill" and lift off. Pour rinse aid into
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting a
flat-blade screwdriver into the center of
the arrow and turning.
Full
Add
Lock
Refill c::::___
¼ turn to lock
STEP3
Select a Cycle (cycles vary by model)
See "Cycle and Option Description" charts in the following section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
Select Options (options vary by model)
See "Cycle and Option Description" charts in the following section.
You can customize your cycles by pressing the options desired.
.......................................... OPTIONS ...................................................... ,
PoScub Sani _ Hi-Temp / Dy * 4Hour'
[ Rnse Stub _ Qo,k Deay
STEP4
Start or Resume a Cycle
• Run hot water at the sink nearest your dishwasher until
the water is hot. Turn off wate£
• Push door firmly closed. The door latches automatically. Select
the wash cycle and options desired OR press START/RESUME
to repeat the same cycle and options as in the previous wash
cycle.
• You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.