Advertisement
Grill
Lighting
Instructions
1. Before
each use, check
all hoses
for cracks,
nicks,
cuts, burns
or abrasions.
If a hose
is damaged
in any
way,
do not use your
grill before
replacing
the hose
with
an authorized
part from the Parts
List. Also make
sure
all gas supply
connections
are securely
tightened.
2. Familiarize
yourself
with
the safety
and Use and Care
instructions
in this manual.
Do not smoke
while
lighting
grill or checking
gas supply
connections.
3. Be sure the LP Gas tank
is filled.
4. Open
the Grill Lid.
5. Check
that the end of each
Burner
Tube
is properly
located
over each
Valve Orifice.
Failure
to replace
a faulty
hose,
secure
gas
supply
connections
or to open
the Lid
before
proceeding
to the
Lighting
Procedures
could
result
in a fire
or
explosion
that
could
cause
serious
bodily
injury,
death,
or property
damage.
6. Set Control
Knobs
to OFF and open
the LP Gas tank
valve SLOWLY
1/4 of a turn.
OFF
Open
LP Gas_
7.
Push and turn the LEFT Control
Knob
to HIGH.
|
HIGH
Side
Burner
Lighting
Instructions
1. Follow steps 1 through 5 of the Grill Lighting
Instructions.
2. Open
Side Burner
Lid.
3. Set Control
Knobs
to OFF and open
the LP Gas
tank
valve SLOWLY
1/4 of a turn.
4. Push and turn the Control
Knob to HIGH.
The built-in
spark
ignitor
will light the Burner
automatically.
5. You may have to push and turn the Control
Knob
up
to 3 or 4 times to light.
6. If ignition
does
not occur,
turn the
burner
Control
Knob
and gas source
OFF and conduct
a leak test of
ALL
gas connections
and fuel
sources.
If no leaks
are detected,
wait 5 minutes
for any gas to clear
and
repeat
the lighting
procedure.
Manually Lighting
Your
Grill
By Paper
Match
To light your gas grill by match,
insert
a match
into the
Lighting
Stick
and follow
steps
1 through
6 of the Grill
Lighting
Instructions.
Then,
light the match
and place
Lighting
Stick
through
the Lighting
Hole on the left side
of the grill as shown
below.
Turn the nearest
Control
Knob
to the HIGH
setting
to release
gas. The Burner
should
light
immediately.
/
/,
OFF
i O
/
8. Immediately
press
the
Electric
Ignitor
for
3-4
seconds
to light
the
Burner.
_
PRESS
©
Lighting
Hole
Lighting
Stick
Match
9.
If ignition
does
not occur
in 5 seconds,
turn the
burner
Control
Knob(s)
and gas source
OFF
and
conduct
a leak test of ALL gas connections
and gas
sources
as explained
in the Use and Care section
of
this manual.
If no leaks
are detected,
wait 5 minutes
for any gas to clear and repeat
the lighting
procedure.
10.
After one Burner
is lit, turn the tank valve SLOWLY
one more
1/4 of a turn for 1/2 of one complete
turn.
11.
Once one Burner
is lit, the adjacent
Burner
can be lit
by turning
its Control
Knob
to HIGH.
Never
lean
over
the grill
cooking
area
while
lighting
your
gas
grill.
Keep
your
face
and
body
a safe
distance
(at least
18 inches)
from
the
Lighting
Hole
or
Burners
when
lighting
your
grill
by match.
19
Advertisement
