Table of Contents
Advertisement
Quick Links
iMPORTANT:
Read and save
these instructions.
iMPORTANT:
Installer:
Leave Installation instructions with
the homeowner.
Homeowner:
Keep Installation instructions for
future reference.
Save Installation Instructions for local electrical
inspector'suse.
Part No. 4329225/9763381
Quick Reference
Table of Contents:
Pages
[]
Before you start
[]
Electrical requirements
[]
Product dimensions
[]
Cabinet dimensions
[]
Countertop cutout dimensions
[]
Vent system requirements
Interior-mounted vent motor
[_-
[]
installation steps
[]
Vent system requirements
Exterior-mounted vent motor
[_-[_
Installation steps
[]
Use and Care information
[]
Accessories
Advertisement
Table of Contents
Related Manuals for KitchenAid KIRD802HSS1
Summary of Contents for KitchenAid KIRD802HSS1
- Page 1 Quick Reference iMPORTANT: Table of Contents: Read and save Pages these instructions. Before you start Electrical requirements Product dimensions Cabinet dimensions iMPORTANT: Countertop cutout dimensions Installer: Leave Installation instructions with Vent system requirements the homeowner. Interior-mounted vent motor Homeowner: Keep Installation instructions for installation steps future reference.
-
Page 2: Parts Supplied For Installation
Mobile home installation Parts supplied The installation of this downdraft for installation: vent system must conform to the Manufactured Home Construction Your safety and the safety of Safety Standards, Title 24 CFR, others are very important. Part 328 (formerly the Federal We have provided many important Standard for Mobile... - Page 3 IMPORTANT: Observe all Wire sizes and connections A U.L.- or C.S.A,-listed, 1/2" governing codes and ordinances. must conform to the (12.7 mm) conduit connector It is the customer's responsibility: must be provided at each end of requirements of the National Electrical Code, ANSI/NFPA 70 -- the power supply cable (at the...
- Page 4 (10.2 cm) 6/8" (15.9 mm) 9" (22.9 cm) Dia. NOTE: A 10" (2.5 cm) round vent system adapter collar attaches over (20,8"cm) this hole. Adapter collar is supplied 16" '_r_ with exterior (15.9 m m) blower. 40.6 cm 16" (40.6 c m) EXTERIOR-MOUNTED BLOWER MOTOR INTERNAL...
- Page 5 1-7/8" 27-1/2" (69.9 c m) f or30" ( 76.2 c m) v ent (4.8 cm) 33-1/2" (86.1 c m) f or36" (91.4 c m) v ent -,_. Some models require a 1/4" countertop deeper than (6.4 mm) 25" (63.5 cm); see cutout dimensions chart below.
- Page 6 Vent system installed under a concrete slab using PVC sewer pipe. 6" (15.2 cm/round metal vent Venting system must terminate Island location 6" (15.2 cm) transition wall the outside. round PVC 6" (15.2 cm/ sewer pipe round metal Do not terminate the vent system vent in an attic or other enclosed area.
- Page 7 6" (15.2 cm) round easily assemble the downdraft level vent system. Remove parts vent system packages, downdraft vent and mark blower box from carton and set 90 ° elbows ,_--6 ft. (1.8 m) -:_-I on protective surface. Remove all shipping materials, tape and protective...
- Page 8 Disconnect power. bracket for rear venting Excessive Weight Hazard green ground Use two or more people to move screw and install downdraft vent. Failure to do so can result in back or other injury. d. Remove screws attaching brackets to each side of blower. [] Insert downdraft vent Reposition...
- Page 9 Turnthe controlknobon 7= Connect v ent systemto To get the most efficient sideof ventto checkthe blower. V entsystemmustendwith from your new retractable operationandspeedof blower. a wall or roof cap.Useduct tapeto downdraft vent, read the Use sealalljoints. and Care Information section If blowerdoesnot operate: •...
- Page 10 Recommended standard cabinet floor. Align top of legs fittings with pencil marks on face of downdraft vent.Tighten screws in legs. upport Attach 10" (25.4 cm) round vent collar plate (supplied with exterior blower system) to front of 90 ° elbow = 45 °...
- Page 11 [] Insertretractable Reconnect power. downdraftvent into countertop cutout.Twopeopleare microswitches behind filters vent box recommended to supportthe ON/OFF knockout weight of the downdraftvent wiring duringlifting. Positiondowndraft cover vent so it is centered in cutoutand parallelto edgeof cutout.Check that downdraftvent is vertical.Then teen green lower...
-
Page 12: Warning --To Reducethe Riskoffire, Electric S Hock, Orinjuryto Persons, Observethe Following
Theretractable d owndraft ventsystem is designed t o remove smoke, cooking vaporsandodorsfromthecooktop area. Forthebestresults, theventshouldbeoperating before cooking is started.If youuselarge or tall utensils, p lace them onthelargerearelement or burner s urface. A higherheat s etting thannormally usedmaybeneeded whenthe downdraft ventis operating. WARNING --TO REDUCETHE RISKOFFIRE, Useproperpansize.Alwaysusecookware ELECTRIC S HOCK, ORINJURYTO PERSONS,... - Page 13 YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE. Outside the 50 United States and Canada, this warranty does not apply. Contact your authorized KitchenAid dealer to determine another warranty applies.
-
Page 14: One-Year Limited Warranty
ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will pay for FSI_ replacement parts and repair labor to correct defects in materials or workmanship. -
Page 15: For Further Assistance
ATLANTIC PROVINCES 1-800-565-1598 For further assistance If you need further assistance, you can write to Please include a daytime phone number in your Inglis Limited or KitchenAid Canada with any questions correspondence. or concerns at: Consumer Relations Department 1901 Minnesota Court... - Page 16 Part No. 4329225/9763381 Printed in Italy. _) 2005 Whirlpool Corporation _ Registered trademarkF Mtrademark of KitchenAid, U.S.A., KitchenAid Canada licensee in Canada 10/2005...