Before Setting Warmer Drawer Controls - Frigidaire CFCS372DC2 Use & Care Manual

Before Setting Warmer Drawer ControMs (some mode s)
Arranging Warmer Drawer Rack Positions
Set the warmer drawer rack in the vertical position as shown below:
The rack can be used in 2 ways:
• In the upright position to allow low profile food items to be placed
both under and on top of the rack (for example, rolls or biscuits on
top of the rack and a casserole dish under).
In the Downward position to allow you to place light weight food
items and empty dishware (for example, rolls or pastries and din-
ner plates).
Upright Position
Downward Position
Setting Warmer Drawer ControMs (some modeJg
Note: The warmer drawer cannot be used during an oven self<leaning cycle. The warmer drawer is equipped with a catch which
may require extra force when opening and closing tile drawer.
Use tile warmer drawer to keep hot foods hot such as: vegetables, gravies, meats, casseroles, biscuits and rolls, pastries and
heated dinner plates.
To Operate the Warmer Drawer
The purpose of the warmer drawer is to keep hot cooked foods at serving temperature. Always start with hot food. It is not
recommended to heat (:old food in the warmer drawer.
All food placed in the warmer drawer should be covered with a lid or aluminum foil to maintain moisture and softness. Do not
cover crisp foods. Do not use plastic wrap to cover food. Plastic may melt onto the drawer and be very difficutt to
clean. Use only dishware, utensils and cookware recommended for oven use in the warmer drawer.
Always use potholders or oven mitts when removing food from the warmer drawer as cookware and plates will
be hot.
To Set the Warmer Drawer Controls:
The control and indicator lights for the Warmer Drawer featu resare located on the control
panel. The temperatures are approximate, and are designated by Ht (high), IVIED
(medium) and LO (low).
1. Touch the ON/OFF pad at the Warmer Drawer control position. The Warmer Drawer
indicator light will flash. Note: If no further pads are touched within 25 seconds the
request to power the Warmer Drawer ON will (:lear.
2. Set the desired power level. Touch UP ARROW once to turn ON the power level for
HI (see Figure 2) or DOWN ARROW to turn ON the power level for LO (see Figure 4).
TheWarmer Drawer indicator light located beside the ON/OFF pad will turn ON steady.
3. Each touch of the DOWN ARROW or UP ARROW pads will decrease or increase
through 6 power levels from HI (see Figure 2) to MED (see Figure 3) to LO (see Figure
4). Note: For best results, preheat the Warmer Drawer before adding the food. An
empty drawer will preheat in approximately 15 minutes.
4. When the food is ready for removal, touch the ON/OFF pad once to turn the Warmer
Drawer OFF.The Warmer Drawer indicator light will turn OFF.
IO
)./}
Z}? #:Y
Figure 1
hiO
@
rned 0
@
JoO
Figure 2
hiO
0
rned •
0
Jo@
Figure 3
hiO
O
reed O
Q
10@
Figure 4