1=800=944=9044
(United States)
1=800=265=8352
(Canada)
Visit our web site at
www.frigidaire.com.
CONCERN
POTENTIAL
CAUSE
i
COMMON
SOLUTION
AUTOHATIC
ICE MAKER
Ice maker
is not mak-
•
Ice maker power switch is Off.
ing any ice.
•
Ice maker has small cube
caught in mechanism.
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Ice maker
is not mak-
ice maker is prOduCing less ice
ing enough
than you expect.
,
Check to see if water dispenser
is dispensing slower than normal
Ice maker
will not stop
•
Ice maker wire signal arm is
making
ice.
being held down by some item
in the freezer.
Ice
c_bes
are
freezing
•
cubes are not being used
together,
frequently enough:
•
Ice cubes are hollow (partially
frozen cubes with water inside),
e
Freezer control is set too warm.
•
Turn power switch to On ("1:") position.
•
Remove small cube from ice maker. The ice and water
filter cartridge may be clogged.
Replace filter cartridge.
Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
ice maker produces approximately four (4)pounds
of
ice every 24 h0urs depending 0n usage conditions.
is:replace
the ice and water filter cartridge:
•
Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
i
Remove ice container and discard ice from COntainer. Ice
maker wi!l produce fresh supplyl
The ice and water fi ter cartridge may be clogged:
Replace
filter cartridge.
•
Set freezer control to colder setting,
Allow 24 hours
'
temperature to stabilize.
OPENING/CLOSING
OF DOORS/DRAWERS
DOOr(s) will
not close,.
Door was closed too ha
caus:
ing
other door to open slightly.
•
Refrigerator is not level: It
slightly:rocks
on the floor when moved
•
Refrigerator is touching a wall
or cabinet,
I
Drawers
are difficult to
•
Food is touching shelf on top of
move.
drawer.
•
Track that drawers slide on is
dirty.
' Close
both doors gently,
'
Ensure floor is level and solidi and Can adequately support
the
refrigerator.
Contact a carpenter tO correct a sagging
or sloping floor.
,
Ensu[e
floor is leve! and solid; and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
•
Remove top layer of items in drawer.
•
Ensure drawer is properly installed on track.
•
Clean drawer, rollers, and track.
See Care & Cleaning.