Advertisement
DOOR
REMOVAL
INSTRUCTIONS
NOTE
You will be pulling approximately five (5) feet of water
tube from the back of the refrigerator.
4
Unscrew the three (3) lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Once both doors are in place, ensure they are aligned
with each other and level (Please see the "Installation"
section for more details), and replace the top hinge cover.
NOTE
When reinserting the water tube and replacing the top
hinge cover, use care to be sure you do not kink the tube.
CAUTION
Be sure doors are set aside in a secure position where
they cannot fall and cause personal injury, or damage
to the doors or handles.
Removing
Freezer Drawer
1 Open freezer drawer.
2
Remove drawer screws on right and left sides (two
(2) screws on each side).
NOTE
Do not remove center screw from freezer drawer. This
is a factory adjustment.
CAUTION
Drawer
is heavy.
Use caution when lifting.
3
Lift drawer up and out to remove.
10
Installing
Freezer Drawer
1
With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are fully
inserted into slots on each side.
Fully Exlend
Drawer Slides
Cabinet
2
3
4
5
Reinstall four (4) drawer screws (two (2) per side),
tighten down, and close drawer (C).
install Screws,
(2) Each Side
Check gasket seal around top, bottom, and sides of
freezer drawer.
If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B).
Be careful not to rotate the drawer.
Push Against
Freezer Drawer
/
A
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
0
6
Tighten four (4) drawer screws,
7
Recheck gasket seal.
8
Install the toe grille by fitting into place.
Advertisement
