Advertisement
Fault Codes
1. If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center.
L
\\
\
HIGH
BUCKET FULL
/
__HUMIDITY
S[ITING
Removing
Collected
Water
1. Emptying the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
LOW
FILTER RESET
POWER
\
v
^
\
RIGIDZ_IRE_J
_
b.
Do not move the unit at this point otherwise
water
may spill on the floor.
c,
Press sides of bucket
gently
to unclip
the bucket
from the unit.
d,
Remove
the bucket
as shown
in the photographs
below
and empty
the bucket,
Discard water from bucket. Water is not potable and cannot be used for drinking.
e,
f.
_;ii?' S,
Replace the empty bucket back into the unit and once seated correctly the unit will start up again.
You should hear a click when the bucket is in the correct position
\
02009
Electrolux Home Products, Inc.
All rights reserved.
Advertisement
