Table of Contents
Advertisement
Cleanin
And Care
27
Disconnect
the power cord before cleaning
or leave the door open to inactivate
the
over during cmeaning°
Exterior
Clean the outside with mild soap and water; rinse
and dry with a soft cloth. Do not use any type of
household or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth
to remove any spills or spatters.
Metal parts will
be easier to maintain
if wiped
frequently
with a
damp cloth. Avoid the use of spray and other harsh
cleaners as they may stain, streak or dull the door
surface.
Stainless
Stee_ Trim-Kit
Cleaners which are marked specifically
for use with
stainless steel may be used for stainless steel trim-kit.
Follow package directions
exactly. Avoid the use of
any harsh cleaners or one not marked for stainless
steel use as they may stain, streak or dull surface.
Touch Contro_
PaneH
Wipe the panel with a cloth dampened
slightly with
water only. Dry with a soft cloth. Do not scrub or
use any sort of chemical cleaners. Close door and
press STOP/CLEAR.
mnterior
Cleaning
is easy because little heat is generated
to the interior
surfaces;
therefore,
there
is no
baking and setting of spills or spattering. To clean
the interior
surfaces,
wipe with a soft cloth and
warm water: DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier soil,
use baking soda or a mild soap; rinse thoroughly with
hot water. The rack can be cleaned with hot soapy
water, rinsed and dried.
Waveguide
Cover
The waveguide cover is made from mica so requires
special care. Keep the waveguide
cover clean to
assure good oven performance. Carefully wipe with a
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly
catch
fire. Do not remove the waveguide cover.
Odor
Removal
Occasionally, a cooking odor may remain in the oven.
To remove, cornbine
1 cup water, grated peel and
juice of 1 lemon and several whole cloves in a 2-cup
glass measuring cup. Boil for several minutes using
100% power. Allow to set in oven until cool. Wipe
interior with a soft cloth.
Turntable/Turntable
Support
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsywater;
for
stubborn stains use a mild cleanser and non abrasive
scouring sponge. They are also dishwasher-proof.
Use upper rack of dishwasher° The turntable motor
shaft is not sealed, so excess water or spills should
be wiped up immediately.
Advertisement
Table of Contents
