Kenmore 116.31079 Owner's Manual page 6

Do not overtighteno
Overtighteningcould strip the screw
holes.
Do not operatethe cleanerwithout
the screw in place.
Using a
screwdriver,
tighten the
screw.
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position. Remove the wire tie
from the power cord_
Lock the cord into
place by forcing it
into the locking
notch on the body
of the quick
release cord hook
as shown° This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
Notch
Power
Upper
Power
Lower
Cord
Wrap the
power cord
around the
upper and
lower cord
hooks.
ATTACHMENT ASSEMBLY
After the handle has been assembled to the
body and the power cord has been wrapped
around the cord hooks, the attachments can
be assembled.
1, The hose can then be routed in front of
the handle and over the hose support.
2, The hose can then be placed over the
end of the short hose, twisting as you push
down.
3. The dusting brush can be placed on the
wand and placed in the holder in front of the
hose with the brush portion up.
4. The crevice tool can be slipped down
into the holder beside the wand.
Hose
Hose
Support
Dus ring
Brush
Hose