Advertisement
SECTION 5: MAKING ADJUSTMENTS
WARNING:
Disconnect
the spark plug
wire and ground
it against
the engine
before performing any adjustments.
Engine Adjustment
Refer to the separate engine manual for engine
adjustment instructions.
WheelAdjustment
To adjust the wheel yoke and wheel position, refer to
the Operating Section.
DepthStakeAdjustment
To adjust the depth stake to a desired position, refer to
the Operating Section.
ClutchControl A djustment
Periodic adjustment of the belt tension may be required
due to normal stretch and wear on the belt. To adjust
the clutch control lever, refer to the Assembly Section.
TineWidthAdjustment
The tilling width of the unit is 22 inches. Tilling width can
be increased to 24 inches by removing the clevis pins
and hairpin clips, sliding the outer tines out one inch,
and securing in this position with the clevis pins and
hairpin clips. For cultivation, reduce the tine width to 13
inches by removing the outer tines completely.
See Figure 10
/
\
•I
24"
=-
13"
-_
Figure 10
11
Advertisement
