Amana ATB2135HRQ Owner's Manual page 12

If you will be gone for a month or less,
leave the controls at the usual settings.
During longer absences:
1. Remove all food.
2. Shut off the ice maker (if installed) and
the valve where you tapped into the
water line to supply the refrigerator.
3. Disconnect the refrigerator from the
electrical outlet.
4. Clean and dry the refrigerator
thoroughly.
5. Leave the doors open to prevent
odors.
When moving, follow steps 1-4 under
Vacations. In addition, remove and care-
fully pack any items that are easily
removable. Ship the refrigerator in an
upright position with the doors taped
shut.
Refer to the chart on the following page for
specific refrigerator cleaning guidelines.
Disconnect the power cord before
cleaning,
CLEANING UNDERTHE
REFRIGERATOR
Yourrefrigeratorcan be rolled out for clean-
ing the floor underneath.Raisethe leveling
screws if engaged (see page 2). Pull the
refrigeratorstraightout from the wall.
REPLACING A
LIGHT BULB
Disconnect the power cord before
replacing light bulb(s),Wear gloves
as protection against broken glass.
Always use a standard 40 or 60 watt
appliance bulb.
Refrigerator
The light bulb(s) is/are located under the
top of the refrigerator compartment.
To replace:
Unscrew the light bulb and replace.
Freezer
Some models are equipped with a freez-
er light. This light is located on the back
wall of the freezer compartment, near the
upper right corner.
To remove the bulb cover:
Grasp the top and bottom of the bulb
cover. Press in the areas of the attach-
ment tabs, applying enough pressure
to unhook the tabs. At the same time,
pivot the cover down and remove.
Unscrew the light bulb and replace.
Replace the bulb cover by pivoting it
back into place and snapping the tabs
into the appropriate slots.