Advertisement
Care and Cleaning
Burn Hazard
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher
and is not covered by
warranty.
Outside-occasionally
wipe with a mild
nonabrasive
detergent and water. Rinse and dry.
Inside-The
inside of the dishwasher,
including the filter,
is self-cleaning
with normal
use. If needed, clean around the tub gasket area
with a damp cloth.
Property Damage Hazard
Freezing
temperatures
may cause water lines to
rupture. Be sure all supply lines to and circulating
lines within dishwasher
are protected.
Failure to do so could result in property
damage.
.... .,
Winterizing
A dishwasher
left in an unheated
place
should
........ _
be protected
from freezing.
Have a qualified
"i
person
do the following:
;_o
,_
_.u Disconnect
Service:
• Turn off electrical power to the dishwasher at
Spray arm/tower
assembly
Note: Hard water may cause lime deposit
buildup
on the interior of the dishwasher.
For cleaning
instructions see "Removing
Spots and Film"
section.
Overfill
Protector--keeps dishwasher
from overfilling and is located in the left front
comer of the tub.
•
Clean occasionally
with household
cleaner containing
vinegar or
bleach to dissolve
any buildup.
•
Overfill
Protector
should move up and
down freely about
one inch. If it does
not move, lift and clean underneath.
the supply source by removing fuses or
tripping circuit breaker.
2.
Shut off water supply.
3.
Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4.
Disconnect drain line from pump and drain
water into pan.
Note: See Installations Instructions for more
details•
To Restore Service:
1.
Reconnect the water, drain, and electrical
power supply.
2.
Turn on water and electrical power supply.
3.
Fill detergent cup(s) and run dishwasher
through a NORMAL
cycle.
4.
Check connections to make sure they do not
leak.
Note: See Installations Instructions for more
details.
8
Advertisement
