Assembly; Fitting The Loop Handle; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 124L Operator's Manual

ASSEMBLY
NOTE: Make sure unit is assembled cor-
rectly as shown in this manual.
Fitting the loop handle
• Position the handle on the shaft. Note
that the handle must be mounted be-
tween the two arrows on the shaft.
f
I
• Fit the screw, securing plate and wing
nut as shown in the diagram.
• Tighten the wing nut.
Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting on
the shaft and secure with the wing nut (B).
_B
I
• Turn the shaft until one of the holes in the
dust cup aligns with the corresponding
hole in the gear housing.
• insert a small screwdriver (C) into the
aligned holes to lock the shaft.
• Screw on the trimmer head (D) in the op-
posite direction to the direction of rota-
tion.
• To dismantle, follow the instructions in
the reverse order.