Lubricating The Cables; Lubricating In Accordance With The Lubrication Schedule - Husqvarna Z4824 Operator's Manual

LUBRICATION
Lubricating the Cables
If possible, grease both ends of the cables and move the controls to end stop positions when lubricating.
Refit the rubber covers on the cables after lubrication.Cables with sheaths will bind if they are not
lubricated regularty.If a ceble binds, it can disruptoperation.
If a cable binds, remove the cable and hang it vertically.Lubricateit with light engine oil until the oil begins
to escape from the bottom.
_p: Fill a small plastic bag with oiland tape it so that it seals againstthe sheath and allow the cable to hang
verticallyfrom the bag overnight. If you do not succeed in lubricatingthe cable, it must be replaced.
Lubricating in Accordance with the
Lubrication Schedule
1. Caster wheels
Lubricate with a grease gun. One zerk for
each bearing, two strokes. Use only good
quality grease. See General in Lubrication.
2. Engine Oil (Briggs & Stratton)
Changing the Engine Oil
The engine oil should be changed for the first
time after 5-8 hours of operation, Thereafter,
it shall be changed every 50 hours,
Castor wheel zerk
8011-717
WARNING!
Engine oil can be very hot if it is
drained directly after stopping
the engine, Allow the engine to
cool somewhat firaL
English-52