Drain Pump Model - Aficionado C883 User Manual

7. Drain Pump Model
1) Arrange the ice maker at the front of the opening of
installation.
2) Install the inlet pipe (copper pipe with a diameter of
1/4") on the wall and connect the water supply valve.
3) Connect the drain pipe from the wall to the ice maker.
Important Information! An air gap may be required
between the drain tube of the ice maker and the container
of the drain pipe under the provision of local laws and
regulations. Refer to Fig. 6.
5) If the electrical outlet is at the back of the product, insert
the plug into the electrical outlet.
6) Install the product so that the front of the product is
facing forwards.
7) Use the inlet pipe after cutting the required length.
8) Connect the inlet pipe with the water-supply valve of the
product using the flare nut.
9) Cut the required length of drain tube.
10) Connect the drain tube (with a diameter of 5/8") with the
drain pipe at the back of the product and fix them
together using a hose clamp. If required for easy
installation, immerse the drain hose in warm water just
before connection with the fitting.
11) Turn on the tap and check where there is any leakage.
i
]
1
..................................................... I .......
_I_N. 15"(3_ .
Fig. 6 Top View
./
i7
::1
li
12) Pour 3 quarters of the water into the ice container. The
drain pump should work and pump the water upwards.
Check whether the drain pump works or not. Check for
any leakage.
Fig. 7 Front View
13) Turn the switch to the "ICE" position. The compressor will start working in 3-5 minutes.
14) Pour 3 quarters of water into the ice container and block the drain tube while the drain pump is operating. At
this time, check whether the operation has stopped and that the drain pump works continuously.
15) Adjust the leveling legs.
Important Information! Plumbing should be carried out in accordance with all the provisions laid out under
the local laws and regulations.
11