Unassembled Parts; Assembly; To Remove Tractor From Carton; Check Battery - Husqvarna YTH2246 Owner's Manual

UNASSEMBLED PARTS
Key
Slope Sheet
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping
puposes.
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR FROM
CARTON
ADJUST SEAT (See Fig. 2)
• Sit in seat.
• Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
• Release lever to lock seat in position.
UNPACK CARTON
* Remove all accessible loose parts and parts cartons
from carton.
, Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
, Check for any additional loose parts or cartons and
remove.
CHECK BATTERY
1. Lift seat pan to raised position and open battery box
door.
NOTE: If this battery is put into service after month and
year indicated on label (label located between termi-
nals) charge battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance section of this
manual for charging instructions).
Seat
Battery box
Labe!
FiG. 1
FiG. 2
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
TO ROLL TRACTOR OFF SKiD (See Op=
eration section for location and function of
controls)
• Raise attachment lift lever to its highest position.
• Release parking brake by depressing brake pedal.
• Place freewheel control in disengaged position to dis-
engage transmission (See "TO TRANSPORT" in the
Operation section of this manual).
• Roll tractor forward off skid.
5