Hotpoint HTS18CBSELWW Owner's Manual And Installation Instructions page 22

Installation Instructions
B REVERSING THE DOOR SWING
(CONT.)
16IREHANGING THE DOORS
6.1 Rehang the fresh food door
6.1.1 I,ower the fresh food door onto the
botton/ hinge pin. Be sure the washer
is in place on the pin,
8
Washer
Bracket
Modelswith a hingebracket
that has 2 screw holes.
Plastic
Washer
Hinge ._-_-_
Models with a hinge bracket
that has 4 screw holes.
[] REHANGING THE DOORS (CONT.)
6.2 Rehang the freezer door
6.2.1 I,ower the freezer door onto the center
hinge, pin. Be sure the washer and
spacer are in place on the pin.
ge Pin
and Spacer
6.1.2 Insert the pin on the center hinge into the
socket in the top of the door. Place the space_,
then the washer, on the hinge pin.
NOTE: The center hinge must be turned over
as shown when mounted on the left side.
Hinge_,
and Spacer
6.1.3 Tilt the door toward the cabinet. As the (loot" is
brought into position, slide the hinge trader the
head of the screw which earlier had been partly
driven into the outemmst hole. Insert the
remaining scre_, then tighten both screws
sectlrelv.
6.2.2 Tilt the door toward the cabinet, lifting the top
hinge so the pin fits into the socket on the top
of the door.
6.2.3. Make sm'e the door is slightly above the top of
the cabinet and the gap between the doors is
even across the front. Tighten the top hinge
screws. Do not overtighten these screws-tighten
them until they are just snug, then tm'n them
another one-half turn.
22