GE RGB528 Owner's Manual & Installation Instructions page 21

www.GEAppliances.com
Grid
I .......... I
1
! z !
Pan
Broiler Pan and Grid
Mter 1)roiling, renlove tile broiler pan fl'oIn
tile oven. Ren/ove tile grid fl'oIn tile pan.
Carefully pour out grease fl'oIn tile pan
into a proper containei: "vgash and rinse
tile broiler pan and grid in hot water
with a soap-filled or plastic scouting pad.
If tood has burned oil, spi_nkle tile grid
with deteigent while hot and cover with
wet paper towels or a dishcloth. Soaking
tile pan will reniove burned-on too(Is.
Tile broiler pan and grid nlay be cleaned
with a ('oi/illlercial ()',ell cleanei:
Both tile broiler pan and grid can also be
cleaned in a dishwashei:
Do not store a soiled broiler pan and grid
anywhere in the range.
CAUTION: D o n o, clean ,he b roiler
pan or grid in a self-cleaning oven.
ii i
/
Removable Broiler Drawer (on some models)
To remove:
V_ "_q/eil tile broiler is
cool,
reinoxe tile
,LLJ
g6d and pan.
V2] Pull tile broiler drawer ()tit until it
stops, then push it back in about
one inch.
To replace:
Hold tile broiler drawer in tile raised
position
as you slide it partway into tile
range. Then lower tile drawer and push
it conipletely closed.
[] (;rasp tile handle, lift and pull tile
broiler drawer ()/it. Clean tile broiler
drawer with hot soap) wateI:
Ventappearance and location var,A
OvenAir Vents
Never block tile vents (air openings) of the
range. They provide the air inlet and outlet
that are necessaiw fin" tile range to operate
properly with correct conll)ustion.
Mr openings are located at tile rear of
tile cooktop, at tile top and bottoin (if tile
oven d(ioi; and at the bottoin of the range,
under tile kick panel or broiler drawer
(depending oil tile nlodel).
Pull the knob straight off the stem.
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe tile control panel
after each use of tile oven. Use a danIp
cloth to clean or rinse. For cleaning, use
Inild soap and water or a 50/50 sohItion
of vinegar and wateI: For I_insing, use
clean watei: Polish di_' with a soft cloth.
Do not use abrasive cleansei_, strong
liquid cleanei_, plastic scouiing pads
or
()veil cleanei_ on
tile
control
panel--
they will danlage tile finish.
Do not bend
knol)s by pulling
theIn up or
down or by hanging a towel or other such
loads. This can
daniage
the gas wdve shaft.
Tile control knobs nlav be renloved fi)r
easier cleaning. To reniove a knob, pull
it straight off the stein. If knob is difficult
to renlove, place a towel or dishcloth
between tile knob and control panel and
pull gently. "_hsh tile knobs in soap and
water or a vinegar and hot water sohifion.
Metal parts can be cleaned with soap
and wateI: Do not rise steel wool,
abI'asives_ _lillillOili_l_
acids or coi//illei'cial
()veil cleaneis. Dry with a soft cloth.
2/