FujiFilm FINEPIX A340 Owner's Manual page 81

Frame erase does not
erase the frame,
The ERASE ALL
function does not
erase all the frames,
Nothing happens when
press the "Playback"
button on the camera.
iii_i_iiiii`i_`Y_`i_`_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_`_!_iii_:0i_ii:iiii_i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii iii_i_i_iii`i_`_`i_`_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Some frames may be protected. Unprotect frames using the camera on
which the protection was first applied.
• Camera malfunction.
• The batteries run out.
Screens are not • A language other than English is
displayed in English. selected in the ";__/LANG." setting in
SET-UP (,,oP.49).
There is no image on •The included video cable was
the TV. connected during movie playback.
• The camera is not connected to the TV
correctly.
• 'q-V" is selected as the TV input.
• The video output setting is incorrect.
When the camera is •The USB cable (included) is not
connected to a correctly connected to the PC or
3ersonal computer camera.
(PC), the photographed • The PC is not turned on.
image appears on the
camera's LCD monitor.
The camera no longer The camera has suffered an unforeseen
works correctly. 3roblem.
Can't print with ,,z_.,, is not selected in USB mode in
the SET-UP menu.
PictBridge.
The camera was
connected to PC when
the USB mode was
set to ,,z_._.,,
• Briefly remove the batteries or
disconnect the AC power adapter.
Then reload the batteries or reconnect
the AC power adapter and try again.
• Load new or fully charged batteries.
_OPress the "MENU/OK" button to display
the menu on the LCD monitor.
@Press "_1" or "1_" to select "_'_" and
press ",il," or "T" to select "SET-UP"
(SET-UP screen appears on the LCD
monitor).
(t_)Press "_1" or "1_." to move to option 3
and then use ,,A. or "IW" to select
"_/LANG. ".
_)Press "_1" or "1_" several times to select
"ENGLISH".
@Press the "MENU/OK" button.
• After the movie playback mode is
stopped, connect the camera and TV
correctly.
• Connect the camera and TV correctly.
• Set the TV input to "VIDEO".
• Change the setting to "NTSC' or "PAL"
(raP.49).
• Set up the camera and the USB cable
(included) correctly.
• Turn the PC on.
Briefly remove the batteries or
disconnect the AC power adapter. Then
reload the batteries or reconnect the AC
power adapter and try again.
Select "._." in USB mode in the SET-
UP menu.
Perform steps 0) to _) to remove the
camera from PC.
• Windows
¢1_The "New Hardware Found" wizard
(or "Scanner and Camera" wizard)
appears. If the wizard does not
appear, proceed to step C_.
(gp Click the [Cancel] button.
(3j Disconnect the camera from the PC.
• Macintosh
¢1_The window for locating the driver
appears. If the window does not
appear, proceed to step _.
@ Click the [Cancel] button.
(3_ Disconnect the camera from the
Macintosh.
81