Hitachi 51M200A Operating Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
Read before operating equipment
Follow all warnings and instructions marked on this Projection
Monitor.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accor-
dance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use the attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod,
bracket, or table specified by the man-
ufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into apparatus, the apparatus has been
exposed to rain or moisture, does not operate normal-
ly, or has been dropped.
Do not place any objects on the top of the
Projection Monitor which may fall or cause a child
to climb to retrieve the objects.
15. Projection Monitors are designed to comply with the
recommended safety standards for tilt and stability.
Do not apply excessive pulling force to the front, or top,
of the cabinet which could cause the product to over-
turn resulting in product damage and/or personal
injury.
16. Follow instructions for wall, shelf or ceiling mounting as
recommended by the manufacturer.
17. An outdoor antenna should not be located in the vicin-
ity of overhead power lines or other electrical circuits.
18. If an outside antenna is connected to the receiver be
sure the antenna system is grounded so as to provide
some protection against voltage surges and built up
static charges. Section 810 of the National Electric
Code, ANSI/NFPA No. 70-1984, provides information
with respect to proper grounding for the mast and sup-
porting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding connectors,
location of antenna-discharge unit, connection to
grounding electrodes and requirements for the ground-
ing electrode.
[ ANTENNA
DlSC_RGE UNIT
(NEC SECtiON 81020:,
POWER S ERV]CE GROUNDING
_ ELECTRODE SYSTEM
(NEC A RT 250pART H_
NEO NATION_ E LECTRIC_ O ODE
Note to the CATV system installer: This reminder is
provided to call the CATV system installer's attention to
Article 820-44 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry
as practical.
Disposal of this product may require specific
instructions pertaining to your resident state. For
disposal or recycling information, please contact
your local authorities or the Electronic Industries
Alliance: www.eiae.org.
Projection Monitor's are heavy and can mark or damage floor surfaces (especially wood flooring) if moved improperly.
Do not slide or force Projection Monitor into position.
PREVENTION OF SCREEN BURN
This Wide Screen Projection Monitor is designed to display wide screen pictures. Images should be viewed mostly in wide screen
format or zoomed to fill the screen with moving pictures. Use of side panels, top and bottom panels of standard picture formats
should only be t5% of your total viewing time to prevent uneven aging of the phosphors. Phosphors in the lighted area of the pic-
ture will age more rapidly than the gray areas. Continuous on-screen displays such as video games, stock market quotations,
computer generated graphics, and other fixed (non-moving) patterns can cause permanent damage to Projection Monitors. Such
"SCREEN BURNS" constitute misuse and are NOT COVERED by your ASPECT Factory Warranty.
Lead Notice
This product contains lead. Dispose of this product in accordance with applicable environmental laws. For product recycling and
disposal information, contact your local government agency or the Electronic Industries Alliance at www.eiae.org (in the US) or
the Electronic Product Stewardship Canada at www.epsc.ca (in Canada). FOR MORE INFORMATION, CALL 1-800-488-2244.
3