Grounding Instructions; Do Not Use An Extension Cord; Important Warning - Danby Designer DCR34W Owner's Manual

Compact
Hide thumbs Also See for Designer DCR34W:
Table of Contents

Advertisement

Available languages

Available languages

ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded.
In
the event of an electrical short circuit,
grounding reduces the risk of eleclrtcal
shock by providing an escape wire for the
electrical current. This appliance is
equipped with a cord having a grounding
wire with a grounding plug,, The plug must
be plugged Into an outlet that is properly
lnstafled and grounded.
WARNING - improper use of the
grounding plug can result in a risk of electric
shock. Consult a qualified electrician or
serviceman if the grounding instructions are
not completely understood, or II the doubt
exists as to whether the appliance is
properly grounded,
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect
your refrlgeralor to extension cords or
together wllh any other appliance In the
same wall outlet. Do not splice Ihe cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous
attraclion to children Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action thai
will guarantee it harmless.
DANGER;
Rtsk of child entrapment
Before you throw away
youroldreldgeraror ,orfreezer:
,Takeoffthe doors
• Leaw theshelves Inplacesofhatchildrenmay
net easily climb inside.,
DON'T WAil"
DO tT NOWf
Location
1. Select a place wIIh a strong, level floor,,
2, Aliow 5 inches of space between Ihe back of
the refrigerator and any adjacent wall..
3, Avoid direct sunlight and heat. Direct
sunlight may affect the acrylic coating°
Heat sources nearby will cause higher
electricily consumption
4. Avoid very moist places. Too much moislure
in the air will cause frost to form very quickly
on the evaporator, and your refrigerator will
have to be defrosted very frequently,
To avoid vibration, the cabinet must be set level.
To start the refrigerator, turn the temperature
control to the position corresponding to the
desired cooling. The refrigerator temperature
will vary depending on the quantity of the food
stored and on the frequency with which the door
is opened.
Turn the control to the "O" position to.
temporarily disconnect the cooling cycle_ After
defrosling and if the refrigerator has been left out
of use for some lime, set the control to maximum
lot 2 to 3 hours before turning to the desired
posilien. When the refrigerator is not to be used
for a long period of time, disconnect Ihe plug and
leave the door padtal[y open,,
Note: Wait 3 to 5 minutes before reslarting if
operation has been Interrupted
Ice Cube Trey
Ice cube tray Is flexible. Twist tray to remove
ice cubes,, It the Ice cube tray is frozen hard to
the evaporator surface, run a little water over the
tray° Never use a knife or other metal instrument
to remove ice cube tray because this may
damage the evaporator
(Fig. C)
Remove the exterior and interior packings, wipe
the oulstde thoroughly with a soft dry clolh and
the Inside wilh a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct suniighi, or moisture,.
Let air circulate freely around the cabinet.
Keep
the rear of the refrigerator 5 inches away from
lhe wall
Fig. C

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designer dcr34bl

Table of Contents