Clearances Am; Location; Rollers/Leveling Legs; Water Supplytolcemaker - GE TBHA22RRELAD Use And Care Manual

Top-mount no-frost 22 and 25 models with ice dispenser
Table of Contents

Advertisement

PREPARATION
(contilmed)
Refrigerator
Location
Do not install refrigerator
where
temperature
will
go below 60:_F. because
it will not run often enough
to maintain
propel temperatures.
Do install it on a floor strong enough to support it
fully loaded.
Also _ee Energy-Saving
Tips.
Clearances
Allow the following
clearances
for ease of
installation,
proper
air circulation
and plumbing
and electrical
connections:
Side._ .................................
3/4"
Top .......................................
1"
Back . ...................................
_"
If refrigerator
is to be installed
against a wall on the
hinge side. allow 14.:"for door
clearance.
Rollers/Leveling
Legs
Some models have adjustable
rollers
that allow you to move
the refrigerator
away from the
wall for cleaning:
other models
have adjustable
leveling
legs.
Rollers or legs should be set so the
relk'igei'ator
is
firnllypositioned
on
file floor and the front i_ raised just
enough
that the doors close easily
when opened about halfway.
Turn the two front roller adjusting
screx_ s or four comerlevel
i ng legs
clockwise
to raise the refrigemlor.
counterclockwise
to lower
il.
When adjusting rollers or
leveling legs for proper door
closure, we recommend
that the
bottom
front edge of the cabinet be
approximately
3/4" from the floor_
If your refrigerator
has a
base grille, you can turn the
adjusting screws through
openings
in the grille.
If you would
rather
remove
the
base grille, grasp the bottom of the
grille and pull il out.
To replace the base grille, line up
the clips on the back of the grille
with the openings
in the baseplate
and
push
the grille folward
until it
snaps into place.
Water Supply to Icemaker
If your refrigerator
has an icemaker, or if you plan to add an icemaker later,
theicemaker
will have to be colmected to a cold water line. A water supply kit
containing copper tubing, shut-off valve, fittings aud instructions
is available
at extra cost from your dealer. There should be sufficient tubing for the
ieemaker from the cold water supply to allow you to move the refrigerator
om
from the wallseveral
feet (approximately
9 feet of 1/4" copper tubing in three
1()" diameter col is ).
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tbha22rrerad

Table of Contents