GE ASH08 Owner's Manual And Installation Instructions page 13

Install the Case in the Window
[]Cut the window sashseal m the window width
and stick the adhesive side to the bottom of
the sash.
[]Locate the 3 screw holes along the bottom
front edge of the case. Center the case, side-
to-side, in the window and mount it to the
window sill using 3 type B scre,a_.
--'Window sash
seal
[Thread two Woe C bolts into the support
brackets.
Slide the case into the window and lower the
window behind the top mounting rail.
Position the brackets Oil the ease bottom so
they"will be near the outermost point on the
window sill. Attach the support brackets m
each side of the case bottom using 4 type A
screws on each side. _i11ecase should be
slightly tilted to the outside. Use a level;
about a 1/2 bubble will be the correct case
slant to the outside.
13
_ ,Type A screws
/Iy -'T poC o'ts
Top mounting rail
B
screws
Type B screws
[]Extend the left and right accordion panels to
the vertical window sashes and attach with
4 Woe B screws.
Install the Security Bracket and the Foam Top Window Gasket
Cut the foam top window gasket to the [_ Attach the securivy bracket with [_
kkZ3
a type B screw.
window width.
_Stuff the foam between the glass and the
window to prevent air and insects fi'om getting
into the room.
13