GE WlSR2070 Owner's Manual page 13

www.GEAppliances.com
PERFORMANCE(cent) Possible Causes What ToDo
Pilling Result of normal wear on • _,_qfile this is not caused b) the washei, you can slow the
poly-cotton blends and pilling process by washing gam/ents inside out.
fuzzy fabrics
Snags, holes, team, rips Pins, snaps, hooks, sharp • Fasten snaps, hooks, buttons and zippei_.
or excessive wear buttons, belt buckles,
• ]_emove loose items like pins, objects in pockets
zippers mad sharp objects and shaq) buttons.
left in pockets
• Ttu'n knits (which snag easily) inside out.
Undiluted chlorine bleach • Check bleach package ii_strtlctions tor i_roper amotmt.
• Never add tmdihlted bleach to wash or allow clothes
to come in contact with tmdihlted bleach.
ChemicaJs like hair bleach • Rinse imms that inav have chelnicals oi5 theln before
or dye, permmaent wave washing.
solution
Wrinkling
Improper sorting • Avoid mi_ug heavy items (like work clothes) with
light items (like blouses).
• Try a lid)tic sotteuer.
Overloading or • I,oad _otu" washer so clothes haxe enough room
incorrect water level to m_we fl'eelv with water covering all of the clothes.
Incorrect wash mad • Match Cycle selection to the _:pe of tid_ric you are
day cycles washing (especially lor easy care loads).
Repeated washing in • _'_sh in wmm or cold water.
water that is too hot
NOISE Possible Causes What ToDo
Washer is noisy Washer is uneven • To level the ti'ont of the washeI; a(!j ust the ti'ont leveling
legs by rotating the individual leg in the proi_er direction
lor up or down. To level back of washeI; lift back of
machine 4" (11 cm) and set down.
Washer load is • Push the Cycle knob in to stop the washei; open the lid
tmbaJmaced and redistribtlte the load evelflV. Close the lid and restart.
Shipping rod is still assembled • To relnove shiplaing rod ti'om washe_; pull yellow tag and
ha trait attached rod ti'om the bottoln right hand side of washei:
Washer is sitthag too close • Pull washer away froln the wall; about 4" ( l 1 cln) is
to wall (causes knocking needed.
durhag cycle)
OTHER Possible Causes What ToDo
Labels on the exterior
of the washer will not
peel o# cleanly
Occasionally the adhesive
used on the labels does
not release clemfly
• Use a hair dlyer set at the lowest heat setting, directing
the air at the label fin" a short amotmt of tilne. This will
release the adhesive easily, without damaging the stm'hce
ot the washei:
/3