Diagnosticcodes - GE GSD4410 Owner's Manual

About the displaydiagnostic codes.
/2
What/t Means What To Do
p_ Electrlcal power to the dishwasher has been
RESET
interrupted but is now
back on.
ill _ _i
_i_i _ _ii_i _ _
iii_ ii ii ii i _
iill
i i ii iii_ii (iii_
(iii!i_i_ i/_!i i _i_ _i
F ! ¸
i/(L. __ _ iii
IF DISHWASHER WASIN USEWHEN
THEPOWERFAILURE OCCURRED:
1 Press the RESETpad andwait
approximately 30 seconds.
2 Unlatch and ()pen the door.
A If file detergent cup is ()pen and
empty and the dishwasher was set
fbr rim NORMAL POTS PANS or
CHINA CRYSTAL ( ):cle, close
door and put the load through a
RINSE HOLD(Tcle. After the
RINSE HOLD(Tcle is completed,
add dem_gent and reset the load
tbr the washing wcle you wanl.
B If lhe demrgenl cup is closed and
the dishwasher was sel tot the
NORMAL POTSPANSor
CHINA CRYSTAL _ Tcle, resel the
dishwasher fbr the wash cycle
you wahl.
C If the dishwasher was sel tot lhe
RINSEHOLD (Tcle, reset the
dishwasher tbr RINSEHOLD.
IF THEDISHWASHER WAS NOT IN USE
when power fhilure occuned, use
dishwasher as you normally would.
Slow draining. The
dishwasher is taking
longer than normal to
This dishwasher is desig_ed to
automalically compensate tbr longer
than normal drain times, but cycle time
dr_ thewater o .t.
by a blockage in the drain
air gap, a kink in the
dr_ hose, ora
s,opped..p p pe.
_411 b e extended. If this code continues
to appear flequenlly:
I Clean tl_eair gap.
2 Check fbr a kink in the drain hose.
3 Check plumbing fbr slow or
stopped-up drains.
NOTE: W mTanty service does not
cover household drain problems.