Operating Instructions - GE AGW10 Owner's Manual And Installation Instructions

About the controls on the air conditioner.
Features and appearance may vary.
Fan
Only on
Cool on Timer on
Co01 • F1 LOW
I a.%
Fan ! Temp
M Timer Fan
--0
Air Conditioner Controls
Controls
0
@
@
0
ON/OFFPad
Turns air conditioner on and off.
Increase •/Decrease • Pads
Use to set temperature
when in Coolmode.
Mode
Use to set tile air conditioner to Coolor
Fanmode.
Fan Speed Pad
Use to set tile fan speed to LOW(F1),
MED (F2) or HIGH(F3).
Remote Control
0
fimer Pad
ON--When tile air conditioner is off.
it can be set to attmmafically come on in
1 m 12 hours at its previous setting. Each
touch will set tile timer in houls.
OFF_\_31en tile air conditioner is on,
it can be set to attmmatically mrn off in
1 m 12 hours. Each much will set tile timer
in hours.
O
Tocancel thetimer,press tile Timerpad
until tile display time disappears.
Remote Control Signal Receiver
O Display
Shows tile set temperature or time remaining
on timeL
Power Outage Recovery Feature
In tile case of a power outage or interruption, tile
unit will atKomafically re-start in tile settings last
used after tile power is restored. If tile Timer
feature was set, it will resmne its countdown.
You may need to set a new time if desired.
Do Not Operate in Freezing Outdoor Conditions
This cool<rely air conditioner was not designed for
freezing outdoor conditions. It must not be used in
fieezing outdoor conditions.
4
Remote Control
To ensure proper operation, aim tile remote
control at tile sigmal receiver on tile air
condifioneL
Tile remote control sigmal has a range of
tap to 20 feet.
Make sure nofldng is between file air conditioner
and tile remote conuol that could block the
signal.
Make sure batteries are flesh and installed
correctly as indicamd on the remora conuol.