Zoom 3030 player Operation Manual page 35

12: HPS (Harmonized Pitch Shifter)
This effect is for guitar only; it enables diatonic
harmonization for the specified scale.
Parameter 2 Key
Parameter 3 Scale-fine
Parameter 4 Shift
Parameter 5 Mix
Explanation
(2) Key
Determines the key of the scale. The display indicates
both the tuner and the key.
C = C#=
E = F =
G#= A =
(3) Scale-fine
Determines the number of times the harmony is played.
3rd Major =
3rd miner =
(4) Shift
Determines whether to add the harmony above or below.
The harmony sound set with Parameter 3 is added in the
direction set with SHIFT.
(5) Mix
Determines the balance between the effect sound and the
direct sound. When the setting is 0, only the direct sound
is output; the larger the value, the more the effect sound
is output.
Effect Module 6:
EFF2 (Effect 2)
This effect module produces a spatial stereo effect for
chorus, delay, etc. When the SFX effects are used with the
EFF1/SFX effect module, the EFF1/SFX effect module
switches OFF automatically if this effect module is ON.
Parameter 1 Type
Explanation
(1) Type
The effect types can be selected from among the
following. (The contents of Parameters 2-5 differ
depending on the effect type selected.)
1: STEREO CHORUS
2: AUTO PAN
3: MONO DLY
4: PINGPONG DLY
C, C# – A#, B
M3, m3, 4th, 5th, 6th
dn,up
0 – 10
D = D# =
F# = G =
A#= B =
4thr =
5thr = 6thr =
1 – 4
1: STEREO CHORUS
This is similar to Effect Module 1, but produces an
expansive sound in stereo, for the Stereo Chorus effect.
Parameter 2 Depth
Parameter 3 Rate
Parameter 4 Tone
Parameter 5 Balance
Explanation
(2) Depth
Determines the depth of the chorus effect.
(3) Rate
Determines the speed of the vibrato for the chorus effect.
(4) Tone
Adjusts the tonal quality of the effect sound.
(5) Balance
Determines the balance between the effect sound and the
direct sound. When the setting is 0, only the direct sound
is output; when the setting is 10, only the effect sound is
output.
2: AUTO PAN
The sound goes around to the left and right, forward and
back, for a 3D effect.
Parameter 2 Depth
Parameter 3 Rate
Parameter 4 Width
Parameter 5 Clip
Explanation
(2) Depth
Determines the depth for front and back. The larger the
value, the further the sound reaches.
(3) Rate
Determines the speed of AUTOPAN.
(4) Width
Determines the expansion to the right and left. The larger
the value, the further to the right and left the sound
reaches.
(5) Clip
Changes the modulated wave form.
3: MONO DLY (MONO Delay)
This is a conventional delay that produces a maximum
delay time of 1000 ms.
Parameter 2 Time (x100ms)
Parameter 3 TmFine (x1ms)
Parameter 4 F.B
Parameter 5 Balance
NOTE
Delay time can be input by tap input.
0 – 10
1 – 50
0 – 10
0 – 10
0 – 10
1 – 50
0 – 10
0 – 10
0 – 10
0 – 99
0 – 10
0 – 10
33