Visor Mounting; Power Connection - Whistler 1595SE Manual

Visor Mounting

• Slide the visor bracket into the bracket mounting slot.
• Clip the visor bracket onto the visor making sure it is rela-
tively level and has a clear view of the road.
Insert into bracket
mounting slot

Power Connection

• Plug the small end of the power cord into the unit's power
jack.
• Plug the large end into the vehicle's cigarette lighter.
Hardwire Kit Connection
At one end of the power cable the power and ground wires
are separated. The ground wire has a "U" type connector which
should be fastened to a metal surface. Look for an existing
screw or bolt under the dash to use as a grounding point. The
power wire has a spade type connector which should be con-
nected to a switched +12 volt DC circuit in your vehicle's fuse
box. A switched circuit is one that has power when your ve-
hicle is on, but has not power when your vehicle is off.
Connect the "U" type connector to the ground point selected,
plug the power cord into the unit's power jack then touch the
power wire to the +12 volt DC switched power source selected;
if the unit sounds the self test sequence, then all connections
are correct.
INSTALLATION
Slide on visor
8