Orion 250XTR Wiring Diagram

DIN
L + R RCA
INPUT
INPUT
L + R RCA
Power on LED
AUX OUT
Configuration for Input Jumpers
1 2
ON
1 2
ON
Jumper configuration #1
Stereo Output.
Configuration of Crossover and Bypass Cards
1 2
ON
1 2
ON
2 Bypass cards
= no crossover
POWER
AMP
250XTR
50 X 2
275XTR
75 x 2
2150XTR
150 x 2
225HCCA
25 x 2
50 x 2
250HCCA
For questions on this or any other Orion Products, call Technical Support at 1-480-705-5600.
Crossover
The XTR/HCCA amp includes a SLF-1 crossover
module. The card is adjustable for High pass or
Low pass (see diagram). See diagram below for
installation instructions. If the SLF-1 card is not
used, a Bypass card must be put in it's place or
the amp will not pass signal.
Jumper Configuration:
The configuration of jumpers at the left of the
crossover cards determines the output of the
amp. See the diagram below for set-up
instructions. Configuration #1 is for stereo
operation and Configuration #2 is for mono
GAIN operation. To activate the AUXOUT, install the
jumper as shown in configuration # 3. This will
pass full range signal out.
1 2
ON
Jumper configuration #2
Mono Output.
1 2
ON
(1) SLF-1 + (1) Bypass
= 12dB Slope
Lowest Recommend
Fuse Size
Impedance in Stereo
2ohm
30 amp
2ohm
35 amp
2ohm 60 amp
0.5ohm
30 amp
60 amp
1ohm
Technical Brief
How to properly set a 2 channel XTR or HCCA
amp with X-over (removable top plate).
Included amps: 250XTR, 275XTR, 2150XTR,
225HCCA, 250HCCA.
:
1 2
ON
Add these jumpers to
Configuration 1 or 2 for
Full Range from Aux Out.
(2) SLF-1 Cards
= 24dB Slope
THD
S/N
100dB 0.02%
0.02%
100dB
100dB
0.02%
100dB 0.02%
100dB
0.02%
:
SLF-1 Crossover Card Set Up Chart
80hz High pass
80hz Low pass
120hz High pass
120hz Low pass
160hz Low pass
160hz High pass
200hz Low pass
200hz High pass
Input Voltage:
The Gain of the XTR/HCCA
amplifier will accept up to 5v of input signal.
Speaker Plug
DIN Plug Diagram
Wiring Diagram
1
2
3
Frequency
Dimensions
Response
6hz to 30Khz
11" x 8.5" x 2.25"
+/- 0.5dB
6hz to 30Khz
12" x 8.5" x 2.25"
+/- 0.5dB
6hz to 30Khz
18" x 8.5" x 2.25"
+/- 0.5dB
6hz to 30Khz
12" x 8.5" x 2.25"
+/- 0.5dB
6hz to 30Khz
18" x 8.5" x 2.25"
+/- 0.5dB
1. -15 Volts
2. Left Input
3. Ground
5
4. Right Input
4
5. +15 Volts