Craftsman 486.243294 Owner's Manual page 8

CABLE GUIDE
OPERATOR PRESENCE SEAT
SEAT
WIRE
CONNECTOR
SEAT STRAPS
FIG. 1A
INSTALL OPERATOR PRESENCE SEAT TO
TRACTOR
"four Mower is equipped with and Operator Presence
Seat to provide for your safety, The Operator Presence
Seat must be installedon the seat of the tow vehicle
and must be plugged in to the Wire Harness of the
Mower for proper operation of this unit.
NOTE: In order to start the mower engine you must
have the Operator Presence Seal plugged into the Wire
Harness of the Mower and the Mower Blade Clutch
Lever in the disengaged position. In order to enaaQe the
Mower Blades You must be seated on the Tow Vehicle
and on the Operator Presence Seat.
• Place the Operator Presence Seat on the Tractor
Seat with the Wire toward the bottom and secure
with the seat strap. (See Fig. 1A)
• Lift Tractor Seat and install a cable guide in the
middle of the Tractor rear fenders.
• Place Operator Presence Seat Wire into Cable
Guide with the connector toward the rear so as to
connect with the Seat Switch Plug of the Wire
Harness.
• Lower Tractor Seat
• Connect Operator Presence Seat wire to the Seat
Switch Plug of the Wiring Harness,
SAFETY SEAT
WIRING DIAGRAM
SWITCH
ENGINE ONIOFF
_SWITCH
INORMALLY OPEN)
BLUE WiRE
TO LOW£R SPADE OP SWITCH
BLACK WIRE
FROM Ot_OFF SWITCH
TO ENGINE GROUND
ENGINE
TO LOWER SPADE ON SWITCh;
/--BLACK WIRE (A)
_/FROM MODULE TO SWITCH
_(UPPER SPADE)
BLACK WIRE{{3) i_
JLE TO SWITCH
(UPPER SPADE)
RED W_RE {F_ FROM MODULE .f
TO MAGNETO GROUND
_ ELECTFIONIC CONTROL
_\ mOOOLa
-\
)