Table of Contents
Advertisement
5. Install ventilator sheet metal assembly by inserting
the ventilator into the unit – centering between the
tubing on the left and the control panel on the right.
Once the ventilator is fully inserted, slide the
ventilator to align screw hole through the front of
the condenser grille. (See Figure 2.)
IMPORTANT: Position front lip of ventilator on top of
front grille and condenser partition. (See Figure 2
inset.) This is important to ensure proper drainage
of any water entering damper assembly.
FIGURE 2 INSET
SIDE SECTION
6. Open control panel to gain access to unit low
7. Install loose piece wire harness plug into filter tray
8. Plug wire plug from vent package installed in Steps
FIGURE 2
INSTALLATION OF ECONOMIZER
voltage terminal block.
& route wires into low volt box. (See Figure 3.)
(Save back two {2} long red wires with push-on
terminals.)
#1 through #6 into plug installed in Step #7.
Manual 2100-498B
Page
5 of 17
Advertisement
Table of Contents
