Advertisement
Your new tractor has been assembled at the factory with exception of those parts left
unassembled
for shipping purposes.
To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely.
Use the
correct tools as necessary
to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(1) Pliers
(2) 1/2" wrench
(1) Utility knife
(1) Tire pressure
gauge
When dght or left hand is mentioned in
this manual, it means when you are in the
operating position
(seated behind the
steering
wheel).
TO REMOVETRACTOR
FROM
CARTON
UNPACK CARTON
1. Remove arl accessible loose parts
and parts cartons
from carton.
2. Cut, from top to bottom, along lines on
all four corners of carton, and lay
panels flat.
3. Check for any additional loose parts
or cartons and remove.
BEFORE REMOVINGTRACTOR
FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE
EXTENSION SHAFT AND
BOOT
1. Slide extension shaft onto lower
steedng shaft.
Align mounting holes
in extension and lower shafts and
install 5/16 hex bolt and Iocknut.
Tighten securely.
2. Place tabs of steering boot over tab
slots in dash and push down to
secure.
INSTALL STEERING WHEEL
3. Position front wheels of the tractor so
they are pointing straight forward.
4. Remove steering wheel adapter from
steering wheel and sride adapter onto
steedng shaft extension.
5. Position steering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter.
6. Assemble large fiat washer, 3/8 lock
washer, 3/8 hex bolt and tighten
securely.
7. Snap steering wheel insert into center
of steering wheel.
8. Remove protective materials from
tractor hood and gdll.
IMPORTANT:
Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
Steedng
Wheel Insert
Hex Bolt
Lock Washer
rge Flat
)
Washer
Steering
_
Steede9 Boot
E_lt_ _-__"_
Adapter
_-
5/16 Hex
5/16 Locknat_.___
,_J Bolt
Lower
'
'
Sha.
;"
J,
Slots
HOWTO
SET UPYOURTRACTOR
CHECK BATTERY
1. Lift hood to raised position.
NOTE: It this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps, (See "BATTERY" in Maintenance
section of this manual for charging
instructions).
• :
";°
Label
•
,
8
Advertisement
