CHUCK
REMOVAL
See Figure 9,
The chuck must be removed in order to use some
accessories. To remove:
•
Unplug your drill,
,_k
WARNING:
Failure to unplug your drill could
result in accidental starting causing serious
injury.
•
Rotate torque adjusting ring to the maximum
torque setting.
•
Insert a 8 mm (5/16 in,) or larger hex key into the
chuck of your drill and tighten chuck jaws
securely.
•
Tap the hex key sharply with a mallet in a
counterclockwise
direction, See Figure 9.
•
This will loosen the chuck on the spindle.
•
It can now be unscrewed by hand. See Figure 9,
•
Open chuck jaws and remove hex key.
LLET
TORQUE
ADJUSTING
RING
TO RETIGHTEN
A LOOSE
CHUCK
The chuck may become loose on the spindle and
develop a wobble,
To tighten, follow these steps:
•
Unplug your drill,
,_IL WARNING:
Failure to unplug your drill could
result in accidental starting causing serious
injury.
•
Open the chuck jaws.
•
Insert hex key into chuck and tighten chuck jaws
securely. Tap hex key sharply with a mallet in a
clockwise direction.
•
This will tighten the chuck on the spindle.
•
Open the chuck jaws and remove the hex key.
CHUCK
JAWS
KEYLESS
CHUCK
Fig. 9
11